BOSS OC-5 octave Owner’s Manual

BOSS OC-5 octave Owner's Manual

Before using this unit, carefully read “USING THE UNIT SAFELY” and “IMPORTANT NOTES” (supplied on a separate sheet). After reading, keep the document(s) where it will be available for immediate reference.

Panel Descriptions

Precautions When Connecting

  • To prevent malfunction and equipment failure, always turn down the volume, and turn off all the units before making any connections.
  • Once everything is properly connected, be sure to follow the procedure below to turn on their power. If you turn on equipment in the wrong order, you risk causing malfunction or equipment failure.When powering up:Turn on the power to your guitar amp last.When powering down:Turn off the power to your guitar amp first.
  • Before turning the unit on/off, always be sure to turn the volume down. Even with the volume turned down, you might hear some sound when switching the unit on/off. However, this is normal and does not indicate a malfunction.

Use of Battery

  • If operating this unit on battery, please use alkaline battery.
  • The life of the included battery may be limited as its primary purpose was for testing during assembly.
  • When operating on battery power only, the unit’s indicator will become dim when battery power gets too low. Replace the battery as soon as possible.
  • If you handle batteries improperly, you risk explosion and fluid leakage. Make sure that you carefully observe all of the items related to batteries that are listed in “USING THE UNIT SAFELY” and “IMPORTANT NOTES” (supplied on a separate sheet).

Additional Precautions

  • When disposing of the packing carton or cushioning material in which this unit was packed, you must observe the waste disposal regulations that apply to your locality.
  • Do not use connection cables that contain a built-in resistor.

Changing the Battery

  1. Hold down the pedal and loosen the thumbscrew, then open the pedal upward.
  2. Remove the old battery from the battery housing, and remove the snap cord connected to it.
  3. Connect the battery snap to the new battery, and place the battery inside the battery housing.* Be sure to carefully observe the battery’s polarity (+ versus -).
  4. Slip the coil spring onto the spring base on the back of the pedal, and then close the pedal.* Carefully avoid getting the snap cord caught in the pedal, coil spring, and battery housing.
  5. Finally, hold down the pedal while tightening the thumbscrew into the guide bush hole.

Main Specifications

  • 0 dBu = 0.775 Vrms
  • This document explains the specifications of the product at the time that the document was issued. For the latest information, refer to the Roland website.
  • Roland and BOSS are either registered trademarks or trademarks of Roland Corporation in the United States and/or other countries.

For the USASUPPLIER’S DECLARATION OF CONFORMITY

Compliance Information Statement

Model Name : OC-5Type of Equipment : Guitar EffectsResponsible Party : Roland Corporation U.S.Address : 5100 S. Eastern Avenue Los Angeles, CA 90040-2938Telephone : (323) 890-3700

© 2020 Roland Corporation

[xyz-ips snippet=”download-snippet”]

Posted

in

by

admin

Tags:

,