HCM-1CSmall Base CameraCeiling Mount
Setup Guide
What’s Included
QTY 1—Small Ceiling Mount BK/WHQTY 1—1/4″-20x 3/8″ PPH and QTY 2—1/4” Machine Screw Flat Washer (Fig 1, #1)QTY 1—10/32 x 1/4” cup point set screw (Fig 1, #2)QTY 1— 3/32” long-arm hex wrench (for set screw) (Fig 1, #3)
Mounting Instructions
Step 1Screw 1” NPT pipe, or pipe nipple, to a properly installed mounting plate or pipe flange (Fig 2).Tighten until pipe can no longer be tightened with a pipe wrench.If using a 1.5” plate or flange you must us a 1.5” – 1” reducing bushing (Fig 3).NOTE: Plate/flange, reducer bushing, and 1” NPT pipe or nipple are not included.
Step 2Screw mount to pipe securely, engaging a minimum of 1/2” of pipe into mount (Fig 4). When aligned to desired location, tighten set screw (Fig 1, #2) to 30-36 in-lbs of torque (this is approximately when the set screw will stop moving and the long arm of the “long-arm hex wrench” (Fig 1, #3) will start to bend lightly).
Step 3 / 4Mount camera upright to top of mount or invert to bottom of mount with included 1/4-20 machine screw. (Fig 1, # 1) Utilize (0,1,2) 1/4” machine screw flat washers as required. (Fig 1, #1) Note: 1/4” machine screw flat washers are to be used depending upon depth of thread insert in base of camera, in order to achieve a snug fit.
Step 4 / 4Pass cabling through pipe or dress to outside of pipe and connect for a clean installation.
Mount Compatibility
| HuddleCamHD | PTZOptics | Other Cameras… |
| HC-WEBCAM-94HC-GOHC-EPTZ-XXXHC3X-XX-G2HC3XA-XXHC3XW-XX-G2HC10X-USB2-XXHC10XA-XXHC10X-XX-G3HC20X-XX-G2 | PT-WEBCAM-80PTEPTZ-XXX-ZCAMPTVL-XXX-ZCAMPT12X-XXX-ZCAMPT20X-XXX-ZCAMPT12X-XXX-XX-G2PT20X-XXX-XX-G2PT30X-XXX-XX-G2 | This mount has been designed for use with most small based cameras utilizing a 1/4-20” mounting hole as can be found on SONY, Panasonic, Cisco, Polycom and Vaddio cameras. |
For more information on HuddleCamHD mounts and other products please visit: https://huddlecamhd.com/
Rev 2.15/15/2020
References
[xyz-ips snippet=”download-snippet”]