Brydon Pendant Light FittingINSTRUCTION MANUAL
Safety Warnings
- These products are only suitable for connection to a 240V~50Hz supply in accordance with current IEE wiring regulations and should be installed in accordance with local Building Regulations and are for indoor domestic use only. They are not suitable for a bathroom location.
- Before installing your light fitting always switch off the mains supply and remove the appropriate fuse or switch off the appropriate circuit breaker before commencing installation.
- This is a Class I product and must be connected to Earth. The terminal blocks are supplied according to the requirements of the fitting.
- Never fit bulbs of a higher wattage than those specified on the label (as these may cause overheating and damage the fitting).
- If you are in any doubt about your competence please consult a qualified electrician.
- These products may contain delicate parts – be careful during handling and maintenance to avoid breakage.
- If any modification is made it will invalidate the warranty and may render the product unsafe.
Care Information
Allow 10 minutes to cool before replacing, adjusting, or cleaning. Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this product.
Assembly/ User Instructions
Before you startPlease read these instructions carefully before fitting and retain for reference. Check the packaging and make sure that you have all the required parts. Follow each assembly step in order to prevent incorrect assembly. Ensure that the product is fully assembled as illustrated before use.The Light pack contains:
- Light fitting.
- Terminal connection block(s).
- Fixing pack.The following tools may be required:
- Selection of cross and flat head screwdrivers.
- Electric drill and assorted drill bits.
- Wire strippers.
- Electrical insulation tape.
These assembly diagrams are intended as a guide – if in doubt consult a qualified electrician.1. Decide on the position of the light fitting or remove the existing light fitting. Take a note of the position of the electrical connections. Ensure there is a solid mounting surface, preferably a wooden joist or joist bridge to support the weight of the light fitting.2. If you want to reduce the overall length of the fitting it is essential that this is done before the fitting is mounted to the ceiling, or connected to the mains supply. Remove the chain links until the desired length is reached. The cable must now be shortened and the excess cable cut and re-connected to the terminal block. Feed the cable up through the plastic bush and form a loop above the ceiling cup, moving the figure of 8 cable restraint down the exposed cable. NOTE: The electric cable must always be longer than the chain to prevent strain from being placed on the cable. If you are unsure about your ability to do this, we recommend you contact a qualified electrician.3. Remove the two side screws (4) and retain the screws for re-use. Use the fixing bracket (1) as a template to mark and make the screw holes, then secure to the ceiling with appropriate screws fixings (2).4. Support your fitting and connect the house wiring to the terminal block (3) – see expanded wiring details below. NOTE: This is a Class I fitting and must be earthed. Any loose terminal blocks – not secured to the ceiling cup – should always be covered with 2 layers of good quality insulation tape.5. Secure the ceiling cup over the bracket by using the screws (4) removed in Point 3.
Assembly/ User Instructions Continued
6. Remove the shade (6) by loosening the thumbscrews (7), then fit the bulb (5). NOTE: Never fit bulbs of a higher wattage than those specified on the label (as these may cause overheating and damage the fitting).7. Replace the shade, then turn on the power and test.
71123_71124_72460_72461-Brydon-P 20180928
[xyz-ips snippet=”download-snippet”]