Owner’s Manual
brondell LumaWarm Heated Nightlight Toilet Seat
Round(A lo ancho, Rond) : L60-RW /L60-RB
This manual contains important safety information.Please read it carefully before product installation or use.
PLEASE DO NOT RETURN THIS PRODUCT TO THE STORE BEFORE CONTACTING BRONDELL
IMPORTANT SAFEGUARDS
IMPORTANT SAFEGUARDS GROUNDING INSTRUCTIONSThis product should be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This product is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into a 120V GFCI outlet that is properly installed and grounded.
DANGER – Improper use of the grounding plug can result in the risk of electric shock. If repair or replacement of the cord or plug is necessary, do not connect the grounding wire to either flat blade terminal. The wire with insulation having an outer surface that is green with or without yellow stripes is the grounding wire.
Check with a qualified electrician or serviceman if the grounding instructions are not completely understood, or if in doubt as to whether the product is properly grounded.
If it is necessary to use an extension cord, use only a three wire extension cord that has a three-blade grounding plug, and a three-slot receptacle that will accept the plug on the product. Replace or repair a damaged cord.
IMPORTANT SAFETY INSTRUCTIONS
When using electrical products, especially when children are present, basic safety precautions should always be followed, including the following:
IMPORTANT SAFEGUARDS
READ ALL INSTRUCTIONS BEFORE USING
DANGER -To reduce the risk of electrocution:
- Do not use while bathing.
- Do not place or store product where it can fall or be pulled into a tub or tank.
- Do not place in or drop into water or other liquid.
- Do not reach for a product that has fallen into water. Unplug immediately.
WARNING -To reduce the risk of burns, electrocution, fire, or injury to persons:
- Close supervision is necessary when this product is used by, on, or near children or invalids.
- Use this product only for its intended use as described in the owner’s manual. Do not useattachments not recommended by the manufacturer.
- Never operate th is product if it has a damaged cord or plug, if it is not working properly, ifit has been dropped or damaged, or dropped into water. Return the product to a servicecenter for examination and repair.
- Keep the cord away from heated surfaces.
- Never use while sleepy, drowsy, intoxicated, or under the influence of medication thatmay affect your judgement.
- Never drop or insert any object into any opening or hose.
- Do not use outdoors or operate where a erosol (spray) products are being used or whereoxygen is being administered.
- Connect this product to a properly grounded GFCI outlet only. See Grounding Instructions.
SAVE THESE INSTRUCTIONS
INFORMATION TO THE USERSThis equipment has been tested and fo und to comply with the limits for a Class B digital device,pursuant to part 15 of the FCC Rules. These limits are design ed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the distance between the equipment and rece iver.
- Connect the equipment into an outlet on a circuit different from that to which the receiveris connected.
- Consult the dealer or an experienced radio /TV technician for help.
WARNINGAny changes or modifications not expressly approved by the manufacturer could void the user’sauthority to operate the equipment and void warr anty.
IMPORTANT SAFEGUARDSFor safety reasons, please read this entire manual before use.
Specification
Parts List
Before Installation
Items required but NOT Included: Screwdriver, wrench.Be sure that all parts are on hand before proceeding with the installation.Under normal circumstances, tools are not required for the installation process.However, some toilet bowls may be d981gnad with hard to reach areas, In which case, a screwdriver and wrench may be required.
Installation
Please read these instructions carefully before installing the LumaWarm.Failure to do so may result in damage to the product.
1. Removing Existing Toilet Seat
2. Installing the LumaWarm
- Insert the adjustable Mounting Bolts into appropriate grooves on the bottom of the LumaWarm (US for United States & EU for European).
- Insert the Mounting Bolts through the toilet mounting holes.
- Adjust the seat by sliding it forward or backward along the track to obtain optimum position over the toilet bowl.
- Insert Rubber Washer, Plastic Washer and Plastic Wing-nut, from under the toilet, onto each Mounting Bolt and fasten until snug (repeat process on the other aide).
- Use the Wrench to assist with tightening the Plastic Wing-nut if necessary.
3. Installing the LumaWarm (alternate)
Some toilet fixtures are designed with only top-side access. To install the LumaWarm onto these types of fixtures, an Alternate Mounting Kit is required.
To get a set of the Alternate Hardware, order online at www.brondell.com or call 1-888-542-3355
Plugging in the LumaWarm
- Plug Into a grounded GFCI outlet.
Operation
Seat Temperature Setting
To adjust seat temperature, gently press the 
button. Each lime the button is pressed, a red LED will be lit, representing a higher level of temperature.
Temp. adjustment cycle: off /Low / Mid / High
Nightlight Setting
Tum the nightlight on/off by pressing the “light” button.
Maintenance
Always unplug the LumaWarm before cleaning!
Seat Cleaning
Use a soft, damp cloth and mild cleanser (such as dish soap) to wipe down the seat and lid. NEVER scrub or use harsh, abrasive products to clean the LumaWarm.
For more thorough cleaning, you may remove the LumaWarm. To release, unscrew and remove the Plastic Wing-nut, PlasUc Washer and Rubber Washer that are against the bottom of the toilet mounting holes.
Perform the reverse operation when re-installing the LumaWarm back onto the toilet
Troubleshooting
For other issues or questions please visit our website: www.brondell.com or contact Brondell Customer Service: 1-888-542-3355
Contact Information
Brondell, Inc.P.0.Box 470085San Francisco CA94147-0085
Phone : 1-888-542-3355E-mail : WEB: www.brondell.com
Warranty
1 Year Limited Warranty
Brondell warrants that all products (excludlng consumable Items) shall be free from defectsin material and workmanship under normal use and service.
Warranties do not apply to products that are used for commercial, hospital or other non residential appllcatlon.
Residential Warranties for LumaWarm Toilet Seat Products:
100% Coverage of all parts and labor for the first year from original date of purchase.
Exclusions and Limitations
- BRONDELL warrants its products to be free from manufacturing defects under normal use and service. This warranty is extended only to the ORIGINAL PURCHASER. This warranty does not apply to the Swash line of products.
- BRONDELL’s obligations under this warranty are limited to repairs or replacement, at BRONDELL’soption, of products or parts found to be defective, provided that such products were properly installed andused in accordance with instructions. BRON DELL reserves the right to make such inspections as may benecessary in order to determine the cause of the defect. BRONDELL will not charge labor or parts inconnection with warranty repairs for the first full year from date of purchase.
- BRON DELL is not responsible for the cost of removal, return and/or reinstallation of products.This warranty does NOT apply to:a) Damage or loss which occurs during shipment.b) Damage or loss sustained through any natural or man made causes beyond the control ofBRONDELL, including but not limited to fire, earthquake, floods, etc.c) Damage or loss resulting from sediments or foreign matter contained in a water system.d) Damage or loss resultin9 from negligent or improper installation including installation of a unit in a harsh or hazardous environment.e) Damage or loss resulting from removal, improper repair, modification of the product, or improper maintenance including damage caused by chlorine or chlorine related products.
- This warranty gives you specific legal rights. You may have other rights which vary from state to state.
THIS WRITTEN WARRANTY IS THE ONLY WARRANTY MADE BY BRONDELL. REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY SHALL BE THE EXCLUSIVE REMEDY AVAILABLE TO THE PURCHASER. BRONDELL SHALL NOT BE RESPONSIBLE FOR LOSS OF USE OF THE PRODUCT OR FOR OTHER INCIDENTAL, SPECIAL, FOR CONSEQUENTIAL DAMAGES OR EXPENSES INCURRED BY THE PURCHASER OR FOR LABOR OR OTHER COSTS DUE TO INSTALLATION OR REMOVAL OR COSTS OF REPAIRS BY OTHERS, OR FOR ANY OTHER EXPENSE NOT SPECIFICALLY STATED ABOVE. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ANY IMPLIED WARRANTIES, INCLUDING THAT OF MERCHANTABILITY, ARE EXPRESSLY LIMITED TO THE DURATION OF THIS WARRANTY. SOME STATES DO NOT ALLOW LIMITATIONS, SO THE ABOVE LIMITATION AND EXCLUSION MAY NOT APPLY TO YOU.
How to Obtain ServiceTo obtain repair service under this warranty, you must contact an authorized BRONDELL Service Center to obtain an RMA (Return Merchandise Authorization} number. Proof of purchase in the form of a copy of your original receipt must accompany the returned unit for the warranty to be valid. Take or ship the unit pre-paid to the closest Brondell authorized service center along with your RMA number and proof of purchase.
To obtain your RMA number and locate the BRON DELL Service Center location nearest you, call 1-888-542-3355
Product Registration
To ensure you receive important warranty and product information, please register on-line at:http://www.brondell.com/warranty, within 10 days of purchase.
[xyz-ips snippet=”download-snippet”]