Woods Humidifier HSW100 Instruction Manual

Woods Humidifier HSW100 Instruction Manual

Visit our website to:

Get usage advice, updated brochures, troubleshoot and service information Register your product for additional services: www.warranty-woods.com

CUSTOMER CARE AND SERVICE

Always use original spare parts. When contacting our Authorised Service Centre, ensure that you have the following data available: Model number, receipt and serial number.Warning / Caution-Safety information. General information and tips. Environmental information. Subject to change without notice.

Manual HSW100 Humidifier

Content Eng

• Getting started
• Cleaning
• Safety
• Problem solving
• Technical data

Getting started

• Connect the supplied AC adapter
• Connect the unit to an electrical outlet
• Ensure that the humidifier is stable and in balance by adjusting the feet as needed. Otherwise, there is a risk that the water will run out.
• The red water indicator lights up when the water level is low and water needs replenishing.
• Filling is done by opening the filler cap and gently pouring water into it.
• When the red water indicator flashes, the tank is full and no more water should be added.
• The water indicator is off when the water level is sufficient.
• Water shall be replenished when the red water indicator is lit solid.
• Important! Avoid adding water before the lamp comes on, as there is a risk of overfilling due to. that the level sensor has not been reset.

Cleaning

The need for cleaning is dependent on-air quality and water lime content and can therefore vary. But in normal use,the cleaning interval is 7 to 12 weeks.

• Disconnect the unit from the mains and wait about 1min until the fan has stopped.
• Remove the front door by grasping the bottom edge and pulling / twitching straight out.
• The door is then fully unscrewed by turning upwards and unlocking
• Remove the filter cells by gently pulling them straight up and then placing them in a bucket or other container during cleaning.
• Lime particles can get trapped in the filter, which reduces capillary capacity. Replace the filters – 180 ° rotated – which will increase the wetting capacity

Safety

Thank you for choosing a Wood’s humidifier! In this manual you’ll find everything you need to know about your Wood’s humidifier. Please keep this instruction manual in a safe place for future reference. For best capacity and to avoid any damage to your product, it is important that you read these instructions carefully before using yourproduct. The Wood’s HSW100 is a low voltage electrical appliance. With a voltage of only 12V, the risk of electrical shock is significantly lowered. However, as with all electrical appliances, it is important to follow a few safety instructions. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mentalcapacities, or lack of experience and knowledge, unless they have been given supervision or instructions concerning use of the appliance by a person responsible for their safety.Children should be supervised to ensure that they do not play with the appliance. If the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service agent.

• Always keep the appliance away from heat sources.
• Do not use the unit outdoors.
• Always unplug the unit before moving it, storing it, cleaning it or maintaining its filter.
• Make sure that it is placed on a solid, flat surface.
• Careless handling or unauthorized alteration of the chord or electronics of the air purifier could void the warranty.
•  The warranty is only valid upon production of a receipt.

Problem solving

Wood’s is manufactured and marketed by:Woods TES Sweden AB.Maskingatan 2-4441 27, AlingsåsSweden.woods.se+46 31 76 13 610

Read More About This Manual & Download PDF:

References

• 
  We’re helping people and businesses control their air quality
• 
  Warranty Woods
• 
  Warranty Woods
• 
  📧[email protected]