Schlage Custom FC21 Combined Interior Lock Installation Manual

       

P518-149

Installation Instructions

Model FC21, Combined interior

This lock can be installed as passage (hall/closet) or privacy (bed/bath). See the included Privacy function kit.

a. Knob/Lever

b. Trim

c. Exterior chassis

d. Latch

e. Interior chassis

f. Chassis screws

g. Backplate

h. Faceplate

i. Drive-in faceplate

j. Latch/strike screws

k. Strike

l. Hex wrench (Do not discard!)

1 Watch the installation video.

Go to Schlage.com/faqs-custom.

2 Check door dimensions.

2a If dimensions do not match, you may need to modify your door.

For further assistance, call Customer Service at (888) 805-9837.

2b Check latch length.

Measure the backset as shown above.

  • 2 ³⁄₈” (60 mm): no adjustment is necessary.
  • 2 ³⁄₄” (70 mm): see the Adjust latch section.

3 Install the latch

3a Install backplate.

This backplate is backward.

Rotate into place. Notch goes here.

OR

3a Install drive-in faceplate.
Push to snap.
3b Add faceplate and secure with screws.
Bevel must face door frame!, Actual Size

OR

3b Use wood block and hammer.
Bevel must face door frame!

4 Install the strike onto the door frame.

Use included strike for best performance.

Actual Size (2)

5 PRIVACY FUNCTION ONLY: Choose privacy pin location.

Location is based on preference and does not change the function.

Pin on bottom, go on to step 6

OR

Pin on top, go to Schlage.com/faqs-custom.

6 Identify the exterior and interior chassis

Exterior Chassis, Posts, Interior Chassis, Slots, Pegs

7 Install the exterior chassis.

Push firmly!

8 Install the interior chassis.

8a Chassis is spring-loaded. Push pegs into slots and hold in place.

8b Secure with two (2) screws.

Make sure chassis is straight!

Hold in place
Actual Size (2)

9 Install the trim.

Align hole in trim with hole in chassis.

hook, click

OR

hook, click

Repeat for the other side of the door.

10 Install the exterior knob/lever.

10a Push knob/lever firmly into place.

10b Then tighten set screw.

11 PRIVACY FUNCTION ONLY: Install the privacy pin.

Follow the included

Privacy function kit instructions.

Emergency unlock tool, Privacy pin, Pin cap

12 Install the interior knob/lever.

12a Push knob/lever firmly into place.

12b Then tighten set screw.

Adjust latch

For 2 ³⁄₄” backset, rotate and pull latch out to long setting.

Customer Service

(888) 805-9837             www.schlage.com

Schlage Custom FC21 Combined Interior Lock Installation Manual – Schlage Custom FC21 Combined Interior Lock Installation Manual –

[xyz-ips snippet=”download-snippet”]


Posted

in

by