IKEA Omlopp LED Cabinet Lighting Instructions

Table of Contents

IKEA Omlopp LED Cabinet Lighting Instructions

IMPORTANT SAFETY INSTRUCTIONS

For indoor use only. Regularly check the cord, the transformer and all other parts for damage. If any part is damaged the product should not be used.Important information! Keep these instructions for future use

CAUTION!

The light source of this product is nonchangeable light diodes (LED).Do not disassemble the product, as the light diodes can cause damage to the eyes.Do not immerse in water. Cleaning Use a damp cloth, never a strong cleaning agent.

CAUTION

To reduce the risk of fire, electric shock, or injury to persons: Use only insulated staples or plastic ties to secure cords. Route and secure cords so that they will not be pinched ordamaged when the cabinet is pushed to the wall. Position the portable cabinet light with respect to the cabinet so the lamp replacement markings can be read during relamping. Not intended for recessed installation in ceilings, or soffits. The low-voltage portable cabinet light may be installed inside or under a kitchen cabinet or other built-in furniture when:

The low-voltage Class 2 power supply is located outside the cabinet and is not concealed; and
The line voltage power supply cord is not concealed or run through openings in the cabinet, walls, ceilings, or floors. This requirement does not apply to the wiring between thecabinet light and the power unit. The National Electric Code (NEC) does not permit cords to be concealed where damage to insulation may go unnoticed. To prevent fire danger, do not run cord behind walls, ceilings, soffits, or cabinets where it may be inaccessible for examination. Cords should be visually examined periodically and immediately replaced when any damage is noted.

ATTENTION: CAUTION:

Injury to persons and damage to the lamp and/or the mounting surface may result if the lamp is pulled from the surface. To reduce the likelihood of such injury or damage, mount only on a surface that is mechanically sound.

WARNING

Deviation from the assembly instructions may result in a risk of fire or electric shock.This device complies with part 15 of the FCC Rules. Operation is subjected to the following two conditions:

This device may not cause harmful interference, and
this device must accept any interference received, including interference that may cause undesired operation.