HEADRUSH HRB 3027 True Wireless Earbuds Instruction Manual

Instruction Manual8088665TRUE WIRELESS EARBUDSHRB 3027

INTRODUCTION

Thank you for purchasing the HRB 3027 true wireless earbuds In order to maximize your listening experience dente reed the flowing instruction.

  1. Earbuds LED indicator/microphone
  2. MFB (Multhfunetion button)
  3. Charging erne LED indicator
  4. Micro US8 charging poet
  5. Micro US8 thorgiv cable

Additional large and small earbuds tips included(medium tips installed on earbuds).

WHAT’S INCLUDED

  • HRB 3027 earbuds
  • Charging ceps
  • Small, motion, and Large Nand tips
  • Micro US8 charging cable
  • Instruction menial

OPERATING INSTRUCTIONS

Prior to first use, remove the plastic battery isolator tab located between the earbuds and the charging case.

TO DO THIS
Power ON Remove the earbuds from the charging case or press and hold both MFB buttons for 3 seconds.
Power OFF Place earbuds back in the charging case or press and hold both MFB buttons for 5 seconds.
Play/Pause Press either MFB button once.
Next song Press the right MFB button twice. The green LED will flash once every 5 seconds.
Previous song Press the left MFB button twice. The green LED will flash once every 5 seconds.
Answer a call Press either MFB button once. The green LED will flash once every 5 seconds.
End a call Press either MFB button twice. The green LED will flash once every 5 seconds.
Reject an incoming call Press and hold either MFB button for one second. The green LED will flash once every 5 seconds.

NOTE: The function compatibility may vary among different smartphones or devices. Not all functions are available on all devices.

CHARGING THE CASE

Use the included charging cable to fully charge the case before first use. It will take approximately 2.5 hours to fully charge.The red LED will turn ON during charging, and the green LED will turn ON when charging is complete.

CHARGING THE EARBUDS

The earbuds will automatically power OFF and begin charging when they are placed in the charging case. The red LED will stay ON to indicate the earbuds are charging and the green LED will turn ON when charging is complete. It will take 2.5 hours to fully charge the earbuds. The earbuds can be charged 3 times using a fully charged case.NOTE: During use, the red LED on the earbuds will flash three times and beep once to indicate their battery level is low. Please charge the earbuds.

PAIRING

The earbuds will automatically enter Bluetooth pairing mode when used for the first time. The left and right earbuds connect to each other.

  1. Remove both earbuds from the charging case. Press and hold for 3 The green LED will flash, then red LED and green LED flash alternately to indicate the earbuds have powered ON.
  2. Select “HRB 3027” on the Bluetooth device list to pair the earbuds automatically.
  3. When the earbuds are successfully paired the green LED will flash every 5 seconds.
  4. After the initial pairing, the earbuds will automatically turn ON and connect to your device when removed from the charging case, provided both earbuds and your Bluetooth” are ON and within range.

TO USE ONLY THE LEFT OR RIGHT EARBUDIf both earbuds are turned ON and paired to your device, you can return the right or left earbud to the charging case and the earbud (R or L) in your ear will continue to play. To use the right or left earbud only, remove it from the charging case. It will turn ON and connect automatically to your device.

RESET

If the left and right earbuds do not connect to each other, you will need to reset the earbuds and clear paired memory.

  1. Remove “HRB 3027” from your device and turn Bluetooth OFF on your device.
  2. Press either MFB button four times (do this firmly in the center) to enter “Reset Mode”. DO NOT hold for more than 1 second on each press.
  3. The green LED will flash, then the red and green LED will flash alternately until you hear a beep. This indicates that the reset procedure has been completed.
  4. Turn Bluetooth back ON in your device settings and select “HRB 3027”.

OPERATION

  • While playing music, press either MFB button to pause, press again to resume
  • Quickly press the right MFB twice for the next song, quickly press the left MFB twice for the previous song
  • The music will pause and the earbuds will ring when there is an incoming call. Press either MFB button once to answer the call, press and hold to reject the call
  • Press and hold either MFB for 5 seconds. The red LED flashes 3 times and power OFF

WARNING!

  • Supervise children when using equipment, this product is not a toy
  • Listening to earbuds at high volume levels, particularly over extended periods of time may damage your hearing
  • If you have a pacemaker or other electrical medical devices, you should consult your physician before using this product
  • The operation of switching on your Hi-Fi system or plugging in the earbuds may cause clicks which at high volume settings may affect your hearing. Therefore, always set the volume control to a minimum before switching between different sources (tuner, turntable, CD player, etc.) or plugging in the earbuds
  • DO NOT use earbuds while driving or cycling
  • The small parts included with this product can be a choking hazard. This product is not intended for use by small children and should be kept away from children under 3 years of age
  • If not used for long periods, it is recommended to charge the earbuds and case at least every 3 months
  • Please dispose of rechargeable batteries properly. DO NOT dispose of batteries in a fire to prevent an explosion

TROUBLESHOOTING

No sound

  • Please check the volume on your audio device to make sure it is outputting sound

Connection Problems

  • Please return the earbuds to the case and then remove them again if there are any connection issues
  • Refer to the cleared paired memory and reset section

The earbuds are not fitting comfortably

  • Please switch out the earbud tips to a different size to find the appropriate fit

Improving the Sound

  • Sound can sometimes be improved by moving to a larger ear tip The ear tips still need to fit comfortably in your ear

CLEANING

Your earbuds may require periodic cleaning. Remove the tips from the earbuds and wash them with a mild detergent and water. Make sure the tips are dry before putting them back on the earbuds.

IMPORTANT SAFETY INFORMATION

CAUTIONS

  • Keep in a safe place free from dust, liquid, and extreme temperatures
  • DO NOT attempt to disassemble the product
  • DO NOT use chemicals to clean the product

SPECIFICATIONS

EARBUDS
Bluetooth® version: V5.0
Bluetooth® profiles*: HSP; HFP; A2DP; AVRCP
Wireless range: 10m (32ft.)
Playback time: Approx. 4.5 hours**
Standby time: Approx. 27 hours
Rated input: DC 5V/22mA
Driver diameter: 6mm
Sensitivity: 92dB±3dB
Frequency response: 20Hz-20kHz
Impedance: 32Ω±15%
Battery: Polymer Lithium
Battery Capacity: 45mAh

CHARGING CASE
Rated input : DC 5V, 200mA
Output : DC 5V, 44mA
Battery capacity : 400mAh

*A2DP-Advanced Audio Distribution Profile, AVRCP-Audio Video Remote Control Profile, FISP=Handset Profile, HFP=l-lands free Profile.**Approximate playback time, battery life depends on individual use and may be more or less than specified.***Bluetooth connected, power ON, no music playing.

Bluetooth

The Bluetooth® word mark and logos are registered trademarks owned by BluetootV SIG, Inc., and any use of such marks by The Source (Bell) Electronics Inc. is under license. Other trademarks and trade names are those of their respective owners.FCC STATEMENT:This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) this device may not cause harmful interference, and(2) this device must accept any interference received, including interference that may cause undesired operation.

CAN ICES-3(B)/NMB-3(B).

FCC REGULATORY COMPLIANCE

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation.If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:– Reorient or relocate the receiving antenna– Increase the separation between the equipment and receiver– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected– Consult the dealer or an experienced radio/TV technician for helpRF EXPOSURE COMPLIANCEThis equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.ISED REGULATORY COMPLIANCEThis device contains license-exempt transmitters that comply with Innovation, Science, and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:This device may not cause interference.This device must accept any interference, including interference that may cause undesired operation of the device.This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment.

THE SOURCE – WARRANTY

The Source warrants that this product will be free from defects in materials and workmanship for a period of twelve (12) months from the date of purchase. Within this period, simply take the product and your proof of purchase to any The Source store or participating dealer and the product will be replaced (where available) without charge. Any product which has been subject to misuse or accidental damage is excluded from this warranty.This warranty is only applicable to a product purchased through The Source company-owned stores or participat­ing dealers in Canada where the warranty is included with the product. While this warranty does not confer any legal rights other than those set out above, you may have additional statutory rights which will vary under the laws of the various countries, states, provinces and other governmental entities in whichThe Source operates. This warranty is subject to all statutory rights you may have in Canada.

Imported by: The Source, Barrie, Ontario, Canada, L4M 4W5Manufactured in Chinawww.thesource.ca© 2021 The Source. All rights reserved. Please Recycle

[xyz-ips snippet=”download-snippet”]

Posted

in

by

admin

Tags:

, ,