WEEE Number: 80133970
INSTALLATION INSTRUCTION
MIRROR LIGHTSVT-7009, VT-7009CH
TECHNICAL DATA:
|
SKU No. |
3983(3000K), 3901(4000K) |
3984(3000K), 3900(4000K) |
| Power: | 8W | 8W |
|
Input Voltage: |
AC:220-240V,50Hz |
AC:220-240V,50Hz |
|
Lumens: |
600lm | 600lm |
|
Beam Angle: |
120° |
120° |
|
CRI: |
>80 | >80 |
|
Protection Rating: |
IP20 |
IP20 |
Driver Connections:
1.) For drivers which have to be connected to the lamp make sure the connections are made right. You can also view the driver specification labeled on the product.2.) If the driver is built-in please ignore this section.3.) This section will not be applicable for items that do not require a driver.
| Wire ColoursN – Black or Blue wireGround – Yellow Or Yellow-GreenL – Brown/Red Wire |  |
INSTALLATION DIAGRAM:
INTRODUCTION & WARRANTY
Thank you for selecting and buying the V-TAC product. V-TAC will serve you the best. Please read these instructions carefully before starting the installing and keep this manual handy for future reference. If you have any other queries, please contact our dealer or local vendor from whom you have purchased the product. They are trained and ready to serve you at your best.The warranty is valid for 3 years from the date of purchase. The warranty does not apply to damage caused by incorrect installation or abnormal wear and tear. The company gives no warranty against damage to any surface due to incorrect removal and installation of theproduct. The products are suitable for 10-12 Hours Daily operation. Usage of product for 24 Hours a day would void the warranty. This product is warranted for manufacturing defects only.
ATTENTION!
- Switch off the power before installing or making any adjustment to then lamp.
- Before connecting the power supply, please refer to manual inside or on the box.
- Always consult certified electrician for installation of the lamp/fitting.
- If you need any assistance with installation please contact us at the email address specified at the bottom of the page.
INSTALLATION INSTRUCTION
- Switch off the power.
- Cut appropriate size hole on the wall. Put the rubber plug into the hole. Fix the bracket on the ceiling with screw.
- Connect the AC.
- Install the lamp body into the bracket and tighten the screw safely and solidly.
In case of any query/issue with the product, please reach out to us at: [email protected]For More products range, inquiry please contact our distributor or nearest dealers. V-TAC EUROPE LTDBulgaria, Plovdiv 4000, bul.L.Karavelow 9B
References
[xyz-ips snippet=”download-snippet”]