ULINE S-10756 Fiber Drum
CLOSURE INSTRUCTIONS
Pursuant to the requirements of the Department of Transportation in CFR 49 Part 178.2(c)(1), this method of closure should be used to ensure that your containers have been closed in the same manner as when they were initially tested.
TO CLOSE
- This drum must be used with a polyethylene bag with a minimum 2 Mil thickness. Fill product into the bag. Twist neck of bag tight and fold in half. Tie the neck of bag with wire or plastic.
- Place cover on drum.
- Snap the closing ring over the cover and top lip of the drum. Make sure that the writing on the closing lever is right side up. Also, make sure the bottom edge of the closing ring engages under the top lip of the drum.
- Pull the locking lever closed. At the same time, tap along the entire outside edge of the closing ring, beginning directly opposite the closing lever, with a mallet until the lever is fully closed against the edge of the ring.
- Snap the latch into the lever until it locks, then apply a sealing wire or other sealing device through the holes in the latch lever.
- Drums closed in this manner have met the UN performance test requirements as specified in the container markings.
This UN test certification report form is a sample of the closure notification form. The data on this form reflects the components of the tested sample drums; it details the closing methods followed at the lab.The closure notification form should be completed using information from the actual customer specification.These values may differ from the sample closing instructions supplied with the UN test certification report.
1-800-295-5510www.uline.com
[xyz-ips snippet=”download-snippet”]