audio-technica ATR2100x-USB Streaming/Podcasting Microphone
ATR2100x-USB
- Screw the microphone stand clamp onto the threaded portion of the desk stand. The front of the microphone should be facing the A-T logo on the desk stand.
- Install the microphone into the stand clamp, with ON/OFF switch facing up.
- Extend the tripod legs to provide a wide, secure base, and place the tripod desk stand on a flat surface.
- Use a screwdriver or coin to loosen/tighten the pivot screws for angle adjustment.
- For digital use, plug one of the provided USB cables into the base of the microphone then connect the other end of the cable to your digital recording device.When connecting the microphone to a USB-C port, you must use a USB On-The-Go (USB OTG) cable like the one included.For analog use, plug the provided XLR cable into the base of the microphone then connect the other end of the cable to your analog audio device.When using with equipment that includes a built-in mic, consult that device’s user guide for instructions on disabling its mic.
- Optional headphone monitoring: Connect headphones with 3.5 mm (1/8″) plug into base of microphone. Use the dial to control volume.For a more detailed user manual, visit the ATR2100x-USB product page at audio-technica.com
FCC Notice
WarningThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
CautionYou are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment.
Note:This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:− Reorient or relocate the receiving antenna.− Increase the separation between the equipment and receiver.− Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.− Consult the dealer or an experienced radio/TV technician for help.
Contact:Responsible Company: Audio-Technica U.S., Inc.Address: 1221 Commerce Drive, Stow, Ohio 44224, USATel: 330-686-2600
ICES statementCAN ICES-3(B)/NMB-3(B)
Audio-Technica Corporation (Headquarters)2-46-1 Nishi-naruse, Machida, Tokyo, 194-8666, Japan
Audio-Technica U.S., Inc.1221 Commerce Drive, Stow, Ohio, 44224, USA
www.audio-technica.com© 2021 Audio-Technica Corporation P52820-01
References
[xyz-ips snippet=”download-snippet”]