ULINE H-5121 Marine Shrink Cart Installation Guide

ULINE H-5121 Marine Shrink Cart Installation Guide

TOOLS NEEDED

3/8″ Combination Wrench or Socket WrenchHammer

PARTS

3/8″ Nuts x 8Support Pole D-clip x 4Caster/Frame x 2Support Poles x 2X-Support Poles x 2

ASSEMBLY

1. Attach X-Support Pole (E) to the bottom of Caster/ Frame (C) using 3/8″ nuts (A). Tighten nuts firmly, but not completely, in order to retain flexibility. Repeat process for the other Caster/Frame (C). Note: If the holes at the end of each X-Support Pole (E) do not line up, lightly tap the ends with a hammer until holes line up. (See Figure 1)
2.  Attach X-Support Pole (E) to the backside of the Caster/ Frame (C) using 3/8″ nuts (A). Tighten nuts firmly, but not completely, in order to retain flexibility. Repeat process for the other Caster/Frame (C). (See Figure 2)
3. Place Support Poles (D) in U-shape holders on front side of Caster/Frame (C). Keep Support Poles in place by inserting Support Pole D-clips (B) in the holes on the U-shape holder. To insert Support Pole D-clips (B), first open the D-clip by pulling down on the spring, put through the two holes, and then release the spring. Repeat process for both Support Poles (D). (See Figure 3)
4. Double check all nuts and bolts used in assembly. Tighten each securely.

Contact Us

ULINEPhone: 1-800-295-5510Web: uline.com