ULINE S-10452 Marine Shrink Vent Installation Guide
INSTALLATION
Mount on an unobstructed area on the cover. Do not mount against any hard surfaces. This will not allow proper air flow.
- Vent should be mounted on a vertical, 90° angle to keep rain/ snow from entering. For best results, mount the vent as high as possible. (See Figure 1)
- Hold vent vertically pointing upward. Press the point of the vent in and push the vent upward. The point should pierce the marine shrink cover. (See Figure 2)NOTE: Heavy gauge plastic or fabric covers may require pre-cutting a 2¾ horizontal slit prior to installation.
- While squeezing the end tabs, continue to push the vent upward until it reaches the locking notches. Smooth any wrinkles in the shrink and release the end tabs. (See Figure 3)
NOTE: Heavy gauge plastic or fabric covers may require pre-cutting a 2¾ horizontal slit prior to installation.
CAUTION! Surface temperature of covering material must be above freezing (32°F) during installation of vent.
CAUTION! Some covering materials may require a strip of adhesive tape to be placed across the outside flex-member of vent to prevent side movement of vent after installation.
Contact: 1-800-295-5510Website: uline.com
[xyz-ips snippet=”download-snippet”]