ULINE H-7162 24″ LED Light Installation Guide

Table of Contents

Phillips Screwdriver

CAUTION! Read all instructions and warnings before operating.

WARNING! To avoid serious injury or death from electrical shock or fire adhere to the following safety warnings.

Do not plug in LED light when hands are wet or damp, or when standing on a wet or damp surface or in
Always use in accordance with electrical and safety codes and ordinances, including the most recent National Electric Code (NEC) and with theOccupational Safety and Health Act (OSHA) Volume 1 on General Industry Standards and interpretations.
Always ensure the power source conforms to the requirements on the
Always disconnect the power before servicing or inspecting the LED light for any
For use only on 110V-125V (single phase) and is equipped with an approved polarized

the outlet, rotate the plug. If it still does not fit, contact a qualified electrician.

Do not use an extension cord unless the plug can be fully
The LED light is not waterproof and is not intended for use in showers, saunas or in potentially wet The entry of moisture into the light may cause damage and void warranty.
For indoor use Do not use in flammable or explosive atmospheres. Potential ignition may occur.
Keep away from heating vents, radiators, or other sources of
Keep out of reach of children.

The LED light comes with two magnets (A) for attaching to most metal surfaces.
Adjust the magnet positions for proper mounting distance:a Use a Phillips screwdriver to loosen the screw (B).b Slide the magnet (A) to desired position, then tighten the screw to lock in position.NOTE: Do not remove the screw from the magnet.
Plug into any 110-125V standard wall outlet.
Press the switch (C) to turn on the Press again to turn off the light.

CORD LENGTH	CORD TYPE/GAUGE	LUMENS	MAXIMUM RATING
6 ft.	SJT 18/3	1,635	20 Watts, 120 V AC, 60 Hz

Do not attempt to replace LED If properly cared for the LED light will provide up to 50,000 hours of use.WARNING! Unplug unit before attempting any maintenance.
Remove dirt and grime as soon as it
Use a soft, damp cloth and a mild soap, if needed.
Do not to get the electrical plug
Never submerge any part of the LED light in any solution to clean
Do not use solvents such as gasoline or turpentine to clean