ULINE H-5501 Heavy Duty 5 Channel Cable Protector Instructions

H-5501 HEAVY DUTY 5 CHANNEL CABLE PROTECTOR1-800-295-5510uline.com

INSTRUCTIONS

COMPONENTS

ASSEMBLY

Interlock with dog-bone connectors to extend protection length. (See Figure 1)

  • Inspect areas for safety hazards.
  • Assemble sections by aligning female connectors over male connectors and press with the foot to secure.
  • Open the cover and install cables down into channels.
  • Close cover flush with the base.
  • Test installation for the intended use.
  • Periodically inspect the installation.

CHANNEL CAPACITY

CHANNEL CAPACITY – MAXIMUM DIAMETER
4 Outer Channels 1.375′ width x ln height
Center Channel 1.65′ width x ln height

LOAD CAPACITYThe heavy-duty 5 channel cable protector has different load supporting capabilities depending on the type of vehicle and temperature. The load capacity decreases in warm environments. Test before use and inspect periodically. Suitability must be verified by testing under actual conditions.

MODELNO. LOAD CAPACITY PER TIREMAX LOAD 70°F (21°C) LOAD CAPACITY PER AXLEMAX LOAD 70°F (21°C)
H-5501 16,300 lbs. 32,600 lbs.

OPERATING TEMPERATURE-40° to 120°F (-40° to 48°C)CHEMICAL RESISTANCETested for compatibility with common motor oils, gasoline, and diesel fuel. Limited resistance to brake fluids and other chemicals.MATERIALUV-stabilized polyurethane elastomer.

INSTRUCTIONS CONTINUED

CAUTION! Misuse can cause electrical shock and injury.

  • DO NOT use as a work surface. NO CUTTING, NO DRILLING, NO HAMMERING.
  • Use with momentary loads only. DO NOT place ladders, scaffolds, or any type of structure on the protector.
  • Avoid concentrated loads.
  • Use only on a stable surface. Inclined surfaces, slippery surfaces, and broken ground can cause injury.
  • This protector can be a trip hazard to pedestrian traffic if they are unaware of its presence.
  • Keep the heavy-duty 5 channel cable protector clean and bright.
  • Keep various services, communications, fluids, and power separated. Limit a channel to one service type.
  • Polyurethane is attacked by some chemicals. Always test a small amount for chemical compatibility before using and follow maintenance procedures.
  • Vehicular traffic must pass over the protector slowly and with caution.

MAINTENANCE

  • Store in a clean, dry area.
  • Inspect the protector for damage and replace it if damaged.
  • Remove any foreign materials, solids, and liquids.
  • Keep clean by using a detergent and water solution.

[xyz-ips snippet=”download-snippet”]

Posted

in

by

admin

Tags:

, ,