ULINE H-3878 Slatwall Cube Tower Installation Guide

H-3878SLATWALL CUBE TOWER

1-800-295-5510uline.com

TOOLS NEEDED

PARTS

ASSEMBLY

KICK BASE ASSEMBLY

1. Install camlock pins into the predrilled holes in kick base boards using screwdriver. (See Figure 1)
2. Install camlocks into large holes in kick base boards by tapping them into position with rubber mallet. (See Figure 2)NOTE: Ensure the hole in the side of the camlock always faces outward.
3. Arrange kick base boards to form a square, so that each corner has camlock pins set into the camlocks of the adjacent board. (See Figure 3)
4. Connect camlocks and pins by inserting screwdriver into the top hole of the camlock and turning clockwise. (See Figure 4)NOTE: Tilt screwdriver at an angle while twisting to better lock the camlocks.

SPINNER BASE ASSEMBLY

1. Set spinner base top with underside facing up on a protected surface.
2. Install camlock pins into predrilled holes of the spinner base using screwdriver. (See Figure 1)
3. Set the kick base onto the spinner base so the camlocks and camlock pins match up, and tighten camlocks. (See Figure 5)NOTE: If you do not want the spinner base to rotate, install a screw through the bottom base panel into the top base panel, taking care not to puncture through the surface of the top base panel. This will stabilize the spinner component of the base unit.

CASTERS INSTALLATION (OPTIONAL)

1. Position the casters onto each of the four corners of kick base assembly. (See Figure 6)
2. Using four pan head screws per caster, attach the casters through the predrilled holes on the inside corners of the kick base. (See Figure 6)NOTE: Install all screws before the final tightening to allow for easier alignment of casters.

CUBE PANEL INSTALLATION

1. Flip spinner base top right side up.
2. Install four wooden dowel pins into the pre-drilled holes on the base top.NOTE: Two people are recommended for steps 3 through 5.
3. Install two panels onto the dowel pins so that they form a corner. Locate the holes on the bottom of the panels and set them onto dowel pins. (See Figure 7)
4. Attach panels together by installing confirmat screws into predrilled holes using Phillips screwdriver. (See Figure 8)NOTE: Do not fully tighten screws until all the panels are in place. Once cube panels are in place, tighten screws completely.
5.  Install remaining panels in the same manner.

CUBE TOP INSTALLATION

1. Fit the cube top onto the panels with the dowel pins provided. (See Figure 9)
2. To cover the exposed screw heads, peel the decorative screw caps to expose the sticky back, and carefully center and cover the screw heads.

1-800-295-5510uline.com

0521 IH-3878

References

• 
  Uline.mx – Cajas para Envíos, Materiales de Empaque, Materiales de Empaque, Suministros para Empaque
• 
  Uline.ca – Shipping Boxes, Shipping Supplies, Packaging Materials, Packing Supplies
• 
  ULINE – Shipping Boxes, Shipping Supplies, Packaging Materials, Packing Supplies