ULINE S-14306 Safety Toe Covers Instructions

S-14306SAFETY TOE COVERS

1-800-295-5510  –  uline.com

CSA CERTIFIEDZ334-14 CLASS 7231-02 Grade 1 toe protection Impact protection 125J

SAFETY INSTRUCTIONS

NOTE: Carefully read these instructions before using this CSA-approved product.

WARNING! This product was designed to offer occasional protection against injury to the wearer’s toes due to crushing or falling objects. It is not a substitute for full safety footwear. No protection is claimed against high voltage electricity, cutting, piercing, or perforation. Not suitable for climbingladders.

  • This product can be used only for temporary toe protection and is to be used in conjunction with fully covered non-protective footwear.
  • This product is not to be used for heavy-duty protection (i.e., construction, heavy lifting, etc.).
  • This product is not to be used as a replacement for permanent foot protection required in everyday job use.

NOTE: It is important to check the fit of the product over your normal footwear to ensure the toe cap covers all of your toes. No other type of protection is claimed or intended.Intended for use on flat, hard, walking surfaces with no tripping hazards. A full risk assessment needs to be carried out to ensure that the use of this type of overshoe provides an appropriate level of protection.

  • Impact protection provided is 125 joules

FITTING AND SIZING

  • This product will only perform correctly if used with conventionally shaped footwear items (those with shallow rounded toes).
  • This product is not to be used with open-toe or open-backed footwear.
  • This product is not to be used with pointed-toe shoes where the toes of the user are not sufficiently covered by the protective toe cap.
  •  This product is not to be worn with footwear where the heel height exceeds 60 mm as measured from the ground up to the top of the sole at the breast of the heel.
  • This product should be tight-fitting to keep it in place.
  • If the steel toe cap can be felt pressing on the top of the shoe, then the sole thickness is too great to offer protection and a larger size should be obtained.

WEAR LIFE

  •  Inspect for excessive wear to the sole and upper prior to use.

WARNING! If damaged, the product must be replaced. If the upper has a tear or nick, or if the sole tread has been worn away, or if the steel toe is loose, DO NOT USE. Replace with a new pair.

Occasionally, the product should be cleaned with mild soap and water. Allow drying naturally, away from direct heat.WARNING! Never use caustic or corrosive cleaning agents.STORAGE

  • May be stored in the clear plastic ziplock bag provided. Shelf life unused is 10 years.

NOTE: The suitability of Safety Toe Covers for specific applications must be determined and tested by the purchaser. Régence Footwear Inc. and its distributors assume no responsibility for the suitability of an end user’s selection for a specific application.Always remember that no item of personal protective equipment can provide full protection and that care must be taken while carrying out the risk-related activity. This product can be used only for occasional toe protection in conjunction with additional fully covered footwear.Manufactured by: Chaussures Régence Inc. · 655 rue de l’Argon · Quebec, QC G2N 2G7 website: www.wilkuro.com · e-mail: i[email protected] ISO 9001-2008 Registered Firm

uline.com0421 IS-14306

[xyz-ips snippet=”download-snippet”]


Posted

in

by