H-1903 HEAVY-DUTY GLUE GUN
1-800-295-5510 – uline.com
OPERATION
- Fasten output control adjuster.
- Plug in to a 110 volt outlet.
- Insert the glue stick into the back of the gun.
- Pull trigger several times until glue is set firmly into the inlet tube.
- Turn-ON/OFF switch on.
- Adjust the temperature knob to the desired temperature.
- Allow 3 minutes to warm up the gun and glue stick.
- Apply an appropriate amount of glue by squeezing the trigger.
- The output volume of glue can be adjusted by turning the output control adjuster. Turn clockwise for less glue and counterclockwise for more.
- Bond surfaces by pressing together within 15 seconds after applying hot glue. For best results, surfaces should be clean of any oil and dirt.
- Always use the provided wire support stand-in-between uses when the gun is plugged in.
- Never lay the gun on its side while it is still hot.
- After use, always switch the gun to off, unplug the gun, and use provided wire support until the gun has cooled before storing.
- Never pull glue sticks out of the gun.
- If glue drips excessively, replace the nozzle. To change, heat the gun for a minute until the glue is softened enough to remove the nozzle. While wearing gloves, use a wrench to remove the old nozzle. Flush glue through the gun and attach the new nozzle.
NOTE: Use a short nozzle for general use or a long nozzle for harder-to-reach areas.
SAFETY
- Keep out of reach of children.
- Never touch the nozzle of the gun or hot melted glue. Operating temperatures can reach 450c F and cause severe burns.
- Do not use within 10 feet of any flammable materials. Not for outdoor use or in wet or damp.
- Keep all work areas clean and well-lit.
- Never use this gun with materials other than recommended glue sticks.
- Always wear protective safety equipment, such as gloves, glasses, long sleeve shirts, and pants, when using hot glue guns.
- When inserting glue sticks into a hot glue gun, avoid using too much force. This can cause hot glue to discharge unexpectedly from the nozzle or flow back from the inlet tube.
- Do not store in direct sunlight.
- Do not use extension cords.
- Hot melt glue is not intended to replace structural fasteners or for use when area temperatures reach over 130° F.
H-1903 HEAVY DUTY GLUE GUN
1-800-295-5510uline.com
[xyz-ips snippet=”download-snippet”]