ULINE H-1078 Light Duty Glue Gun Instruction Manual
OPERATING INSTRUCTIONS
- Plug in gun to a 110 volt outlet.
- Insert glue stick into back of gun.
- Pull trigger several times until glue is set firmly into the inlet tube.
- Allow 5 minutes warm-up time for the gun and glue stick.
- Apply appropriate amount of glue by squeezing trigger.
- Bond surfaces by pressing together within 15 seconds of applying hot glue. For best results make sure surfaces are clean of any oil and dirt.
- Always use the provided glue gun stand in between uses when gun is plugged in.
CAUTION! Never lay the glue gun on its side while gun is still hot. - After use always unplug gun and use provided glue gun stand until gun has cooled before storing.
- Never pull glue sticks out of the glue gun.
SAFETY INSTRUCTIONS
CAUTION! Keep out of reach of children.
WARNING! Never touch the nozzle of the gun or hot melted glue as operating temperatures can reach 400ºF and can cause severe burns.
- Do not use within 10 feet of any flammable materials.
- Not for outdoor use or in areas that may be wet or damp. · Keep all work areas clean and well lit.
- Never use this gun with materials other than recommended glue sticks.
- Always wear protective safety equipment such as gloves, glasses, and long sleeve shirts and pants when using hot melt glue guns.
- When inserting glue sticks into a hot glue gun, avoid using too much force as this can cause hot glue to be unexpectedly discharged from nozzle or flow back from inlet tube.
- Do not store in direct sunlight.
- Not for use with extension cords.
- Hot melt glue is not intended to replace structural fasteners or in temperatures reaching over 130ºF.
Contact: 1-800-295-5510Website: uline.com
[xyz-ips snippet=”download-snippet”]