Caterlite CN515 Vacuum Sealer Instruction Manual

Caterlite CN515 Vacuum Sealer Instruction Manual

Safety Tips

Position on a flat, stable surface.

• A service agent/qualified technician should carry out installation and any repairs if required. Do not remove any components on this product.
• Consult Local and National Standards to comply with the following:
  • Health and Safety at Work Legislation
  • BS EN Codes of Practice
  • Fire Precautions
  • IEE Wiring Regulations
  • Building Regulations
• DO NOT immerse the appliance in water.
• The sealing bar becomes hot during use. DO NOT touch the sealing bar during or immediately after operation.
• Do not turn Off at the plug to halt operation; always use the Cancel button.
• Do not use the appliance for anything other than its intended use.
• Only use bags recommended by the supplier/manufacturer with the appliance.
• Always switch off and disconnect the power supply to the appliance when not in use
• Not suitable for outdoor use.
• Keep all packaging away from children. Dispose of the packaging in accordance to the regulations of local authorities.
• If the power cord is damaged, it must be replaced by an Caterlite agent or a recommended qualified technician in order to avoid a hazard.
• Children should be supervised to ensure that they do not play with the appliance.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience or knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
• Caterlite recommend that this appliance should be periodically tested (at least annually) by a Competent Person. Testing should include, but not be limited to: Visual Inspection, Polarity Test, Insulation Continuity and Functional Testing.
• Caterlite recommend that this product is connected to a circuit protected by an appropriate RCD (Residual Current Device).

Introduction

Please take a few moments to carefully read through this manual. Correct maintenance and operation of this machine will provide the best possible performance from your Caterlite product.

Pack Contents

The following is included:

• Caterlite Vacuum Pack Machine
• Instruction manual

Caterlite prides itself on quality and service, ensuring that at the time of packaging the contents are supplied fully functional and free of damage.Should you find any damage as a result of transit, please contact your Caterlite dealer immediately

Location of Controls

Operation

• The Vacuum Sealer automatically comes on when plugged in.
• The Vacuum Sealer is now ready for use.

Vacuum Packing Food

1. Place the food in the bag and remove any excess liquid or food residue.
2. Allow minimum of 25-50mm of space at the top of bag to ensure a good seal.
3. Place the open end of the bag across the Sealing Strip, keeping opening within the chamber ring and close lid, pressing down with thumbs until the locks on both sides engage.
4. Press “Vacuum Seal” button. Indicator light will turn red.
5. Vacuum pump will engage until required vacuum level is achieved. Machine will automatically go into seal mode.
6. Seal Only indicator light will turn red as the machine starts to seal.
7. When sealing is complete red Seal Only light will go out . Press side lock buttons to release lid.
8. Remove bag and inspect bag and seal.(Note: A good seal will look clear upon inspection. If the seal is spotty, incomplete, wrinkled, white or milky, remove sealed portion and run vacuum and seal process again.)
9. To stop process, press “Cancel” button. Machine will stop

Using the “Seal Only” Function

1. Place the open end of the bag across the Sealing Strip, keeping opening within the chamber ring and close lid, pressing down with thumbs until the locks on both sides engage.
2. Press “Seal Only” button.
3. Indicator light will change to red as the machine starts to seal
4. When sealing is complete red Seal only light will go out . Press side lock buttons to release lid..
5. Remove bag and inspect bag and seal.(Note: A good seal will look clear upon inspection. If the seal is spotty, incomplete, wrinkled, white or milky, remove sealed portion and run vacuum and seal process again.)

Cleaning, Care & Maintenance

Switch off and disconnect from the power supply before cleaning.

Always allow to cool before cleaning.

WARNING: Do not allow any water to spill into the appliance when cleaning.

• Use warm, soapy water and a damp cloth to clean the appliance.
• Dry thoroughly after cleaning.
• A Caterlite dealer or qualified technician should carry out repairs if required.

Troubleshooting

Fault	Probable Cause	Solution
The appliance is not working	The unit is not switched on	Check the unit is plugged in correctly and switched on
Plug or lead is damaged	Call Caterlite agent or qualified Technician
Fuse in the plug has blown	Replace the plug fuse
Power supply	Check power supply
Appliance does not remove all the air from the bag	Open end of bag not completely inserted	Open lid and reposition bag
Gaskets dirty	Clean gaskets
Open end of bag is dirty	Clean bag
Bag may be punctured	Replace bag
Incorrect bags used	Call Vacuum Pack machine supplier
Suction nozzle blocked	Clear suction nozzle
Lid is not locked into position correctly	Ensure lid is locked in position correctly
Bags are not sealing correctly	Moisture in bag under the sealing bar	Ensure inside of the bag is dry and free from moisture where it is to be sealed
Incorrect bags used	Call Vacuum Pack machine supplier
End of bag not placed above sealing bar	Move end of bag over sealing bar

Technical Specifications

Model	Voltage	Power	Current	Vacuum Pressure (approx.)	Dimensions h x w x d mm	Weight (kg)
CN515	220-240V 50Hz	110W	0.5A	-0.75 Bar	87 x 357 x 148	1.4

Electrical Wiring

This appliance is supplied with a 3 pin BS1363 plug and lead.The plug is to be connected to a suitable mains socket.This appliance is wired as follows:

• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N

If in doubt consult a qualified electrician.

Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection being required they must be readily accessible.

Compliance

The WEEE logo on this product or its documentation indicates that the product must not be disposed of as household waste. To help prevent possible harm to human health and/or the environment, the product must be disposed of in an approved and environmentally safe recycling process. For further information on how to dispose of this product correctly, contact the product supplier, or the local authority responsible for waste disposal in your area.

Caterlite parts have undergone strict product testing in order to comply with regulatory standards and specifications set by international, independent, and federal authorities.

Caterlite products have been approved to carry the following symbol:

All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of Caterlite.Every effort is made to ensure all details are correct at the time of going to press, however, Caterlite reserve the right to change specifications without notice.