serenelife SLOHT24 Electric Patio Heater User Manual

Table of Contents

SLOHT24Electric Patio HeaterPortable Outdoor Heater with 360 Degree Tip-over Safety Switch

PLEASE MAKE SURE THAT YOU HAVE READ THE MANUAL CAREFULLY BEFORE USING IT.

IMPORTANT INSTRUCTIONS

When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:

Read all instructions before using this heater.
This heater is hot when in use. To avoid burns, do not let bare skin touch hotsurfaces. If provided, use handles when moving this heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least a 0.9 from the front of the heater and keep them away from the sides and rear.
Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended.
Always unplug the heater when not in use.
Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged in any manner. Discard heater or return to an authorized service facility for examination and/or repair.
This heater is not intended for use in bathrooms, laundry areas, and similar indoor locations. Never locate a heater where it may fall into a bathtub or other water container.
Do not run cord under carpeting. Do not cover the cord with throw rugs, runners, or similar coverings. Do not route the cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over.
To disconnect the heater, turn controls off, then remove the plug from the outlet.
Connect to properly grounded outlets only.
Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater.
To prevent a possible fire, do not block air intakes or exhaust in any manner.Do not use it on soft surfaces, like a bed, where openings may become blocked.
A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or flammable liquids are used or stored.
Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.
Always plug heaters directly into a wall outlet/receptacle. Never use an extension cord or relocatable power tap (outlet/power strip).

PREPARATION

Prepare a cross-head screwdriver.
Read this instruction manual carefully before installation and use. Keep this instruction manual and warranty card in a proper and safe place for future use in case needed.

PARTS DESCRIPTIONS:

No.	Part Name	No.	Part Name
1	Base Bracket	6	Washer
2	Deco. Board	7	Screw M4*35
3	Base Cover	8	Cord Clip
4	Base	9	Plug
5	Screw M6*20

ACCESSORIES PACK CHECKLIST:

Accessory Name	Qty
Screw M6*20	2
Washer	2
Allen Key	1

PARTS DESCRIPTIONS:

INSTALLATION

1Put the main body up-side-down (Fig. A). Slide Deco. Board (#2) onto Base Bracket (#1). Put the plug (#9) and power supply cord through the holes on the center of Base Cover (#3) and Base (#4). Then slide Base Cover (#3), Base (#4), and Washer (#6) onto Base Bracket (#1) respectively.
Fix Washer (#6), Base (#4), Base Cover (#3), and Base Bracket (#1) with Screw M6*20 (#5). Clip the power supply cord with Cord Clip (#8) and fix it onto Base (#4) with Screw (#7).

OPERATIONS:

Plugin the unit to a socket. Make sure the power supply is the same as rated.
Press Heater Switch to switch on or off the heater.

CAUTIONS:

High temperature, keep combustible material such as furniture, papers, clothes, curtains at least 3 feet (0.9m) from the front of the heater and away from the side and rear.
The unit must be securely placed on a horizontal and flat surface.
The unit is at a high temperature during operation. It keeps hot for a period after shut down. The potential danger would occur when touching it during this period.
Don’t place the unit close to the curtain and/or other flammable objects otherwise, there will be a danger of catching fire.
Don’t cover the unit with anything during operation or a short time after it’s shut down.
Don’t wrap the power supply cord on the unit.
The unit must be handled with care, and avoid vibration or hitting.
The unit must be securely grounded during operation.
When damaged, the unit must be repaired by a professional repairing team.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified persons in order to avoid a hazard.
The heater must not be located immediately below a socket outlet.
When assembling, keep clear from any board or flammable material.
Do not use this heater with a programmer, timer, or any other device that switches the heater on automatically, since a fire risk exists if the heater is covered or positioned incorrectly.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
The unit is for household use only. It’s not allowed to use in building sites, greenhouses, barn,s or stables where there’s flammable dust.
The head of the unit is at high temperature during operation. Unplug the unit and wait till it’s cool before cleaning.
Don’t use this heater in the immediate surroundings of a bath, a shower or a swimming pool.
Don’t use this unit in a place where causticity or volatile air exists, i.e. dust, steam, gas, etc.
Don’t use this unit as a cloth drier or towel drier.
Don’t use this unit as a sauna heater.
Don’t use this unit as a room heater of heat-storing.
Don’t use this unit in place of animal propagating and raising.
Don’t use this unit in the heating system of the hot air center.
Don’t immerse this unit into the water for cleaning.
The unit should be plugged in a socket, which is easily visible and reachable.
To avoid potential fire hazards, never place your heater or its electrical cord under rugs, or carpeting. Place the electrical cord away from busy areas to avoid accidental tripping and contact.
To disconnect the heater, turn controls off, then remove the plug from the outlet.
Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.
Avoid the use of an extension cord because the extension cord may overheat and cause a risk of fire. However, if you have to use an extension cord, the cord shall be No. 14AWG minimum size and rated not less than 1875 watts.
Surface temperatures become very hot when operating the heater. Children and adults should stay away to avoid burns or clothing ignition.
Young children should be carefully supervised when they are in the area of the heater.
On the glass table of the heater, please don’t place a weight of more than 5 kg.
SAVE THESE INSTRUCTIONS.

GROUNDING INSTRUCTIONS:This heater is for use on 120 volts. The cord has a plug as shown at A in Figure below. An adapter as shown at C is available for connecting three-blade grounding-type plugs to two-slot receptacles. The green grounding lug extending from the adapter must be connected to a permanent ground such as a properly grounded outlet box. The adapter should not be used if a three-slot grounded receptacle is available.

CLEANING:

Unplug the unit before cleaning. It should be wiped with wet cloth.
Don’t use too much water.
Any other servicing should be performed by an authorized service representative.

STORAGE: