SENIX GTC4Q-L Trimmer User Guide

Table of Contents

UPDATEDQUICKSTART GUIDEMODEL No. GTC4QL-L/GTS4QL-L

STILL DIDN’T START?

Follow these next steps below, also found on p. 9 in your product manual…

Release choke by squeezing throttle trigger and the orange choke button pops out.
The engine is now in the run position
Rapidly pull the starter rope until the engine starts.
Allow the engine to run for 30 seconds, then squeeze the throttle to provide fuel to the engine.

Unpacking the Unit


Remove all contents from the carton.	Turn the knob counterclockwise to loosen the coupler and remove the end cap from the attachment (1). Insert while rotating the lower shaft into the coupler until the button locks in the positioning hole. Turn the knob clockwise to tighten the coupler.	Select one of three handle positions based on operator height. Screw the handle andholder together using a screwdriver tighten until secure.	If desired, attach the shoulder strap to the harness hook (on straight shaft model only).

report this ad

NOTICE: The trimmer is shipped without oil in the crankcase. Oil must be added before starting.

Oll and Fuel

Set the unit on a flat, level surface. Unscrew the oil fill plug. Pour the entire containerof oil provided into the oil fill hole. Reinstall the oil fill plug.NOTE: DO NOT overfill. Never add oil to the fuel tank. DO NOT mix oil with gasoline.

Place the unit on a flat, level surface. Remove the fuel cap. Fill the fuel tank. Replace the fuel cap. Move the unit at least 30 ft. (9.1m) from the fuel container and the fueling site before starting the engine.NOTE: Use fresh unleaded gasoline (less than 30 days old).

Starting the Unit


Press the primer bulb 10 times.	Push the choke button in until it clicks.	Crouch is in the starting position.	Pull the starter rope with a controlled and steady motion 5 times to start the engine. Allow warming for 30 seconds before increasing speed.