YAMAHA SPS-5000 Speaker Stand Owner’s Manual

YAMAHA SPS-5000 Speaker Stand Owner’s Manual

Thank you for selecting this Yamaha product.

PRECAUTIONS

• Do not use any speakers other than those listed below as “Compatible Speaker.”
• To prevent the speaker from falling off this speaker stand, be sure to install the speaker using the specified screw supplied in the package.
• Be sure to install this speaker stand on a level and stable floor surface.Otherwise, it may tip over, resulting in personal injury.
• Be careful not to trip on the speaker cable. Otherwise, the speaker stand may tip over, resulting in personal injury.
• Make sure that children do not lean on this speaker stand. Otherwise, it may tip over, causing an accident.
• To prevent this speaker stand from becoming discolored or deformed, do not place it in direct sunlight or close to a heater.
• Wipe this speaker stand using a soft dry cloth to keep it clean. Do not use the benzene, paint thinner, or any type of cloth that contains chemical solvents.
• To move the speaker and the speaker stand, first remove the speaker from the speaker stand.

Compatible Speaker

(as of July, 2016)

• NS-5000

Package Contents

Before you start assembling this speaker stand, make sure that all parts are included in the package.

1. Speaker Stand (SPS-5000)
2. Screw

Note

Pay attention not to drop the speaker stand when you take it out of the box.

Spike

• Spikes are already attached to the legs of this speaker stand.
• The spikes are used to improve the sound quality, prevent wobbling and enable height adjustment, but they can also be removed. (Cushions are attached to the bottom of the speaker stand.)
• If the spikes are not to be used, remove them before setting up the stand.
• Keep the spikes out of reach of children so as to ensure that they are not mistakenly swallowed.

Setup

When installing the speaker, also refer to its Owner’s Manual

1. Check the orientation of the speaker stand.The back side has a sticker attached to the underside.Note
   • Allowing the tips of the spikes to drag along the floor may cause damage.
   • Be careful when installing the speaker or moving the speaker stand.
2. Place the speaker stand at the setup location.TipBy finely adjusting the height of the speaker stand with the spikes, wobbling can be prevented at the setup location. Be careful since loosening the spikes too much may cause them to fall off.
3. Place the speaker on the speaker stand.Note
   • The speaker should be installed/removed by two or more people.
   • When placing the speaker on the speaker stand, two or more people should lift it from the left and right sides and the bottom. Be sure not to pinch your fingers. Otherwise, injuries may result.
4. Adjust the spacer height so the speaker does not wobble.
5. Align the front corners of the speaker and speaker stand, and then secure them with the screw (2)

Note

• When installing/removing the speaker, do not drag the speaker along the top of the speaker stand. Otherwise, the bottom of the speaker or top of the speaker stand may be scratched or peeled off.
• Hold the speaker securely to avoid dropping it.
• Do not tighten the screw too much. If you tighten it with extreme  force,you may damage or deform the speaker or speaker stand.

Specifications

• Dimensions (W x H x D): 393 × 304 (including factory-set height of spikes) × 376 mm (15-1/2″ × 12″ × 14-3/4″)
• Weight: 8 kg (17.6 lbs)

The contents of this manual apply to the latest specifications as of the publishing date. To obtain the latest manual, access the Yamaha website then download the manual file.

Yamaha Global Site: http://www.yamaha.com/Yamaha Downloads: http://download.yamaha.com/