Programmable Digital ThermostatProduct Information
FocusPRO6000 Series
Thermostat controls
Press to select the function displayed just above each button. (Functions change depending on the task.)
Display screen
Program Schedule
You can program four time periods each day, with different settings for weekdays and weekends. We recommend the pre-set settings (shown inthe table below), since they can reduce your heating/cooling expenses.
Wake – Set to the time you awaken and the temperature you want during the morning, until you leave for the day.
Leave – Set to the time you leave home and the temperature you want while you are away (usually an energy-saving level).
Return – Set to the time you return home and the temperature you want during the evening, until bedtime.
To adjust program schedules
- Press SET CLOCK/DAY/SCHEDULE, then SET SCHEDULE.
- Press
or to set your weekday Waketime (Mon–Fri), then pressNEXT. - Press or to set the temperature for this time period, then press NEXT.
- Set time and temperature for the next time period (Leave). Repeat steps 2 and 3 for each weekday time period.
- Press NEXT to set weekend time periods (Sat-Sun), then press Done to save & exit.
NOTE: Make sure the thermostat is set to the system you want to program (Heat or Cool).NOTE: You can press CANCEL PERIOD to eliminate unwanted time periods (except Wake).
Program schedule override (temporary)
Press 
to
immediately adjust the temperature. This will temporarily override the temperature setting for the current time period.
The new temperature will be maintained only until the next programmed time period begins. For example, if you
want to turn up the heat early in the morning, it will automatically be lowered later, when you leave for the day.To cancel the temporary setting at any time, press RUN SCHEDULE.NOTE: Make sure the thermostat is set to the system you want to control (heat, cool, or auto).
Product ManualsSearch online for Resideo 69-1921EFS for the User’s Guide.
CAUTIONEquipment damage hazardTo prevent possible compressor damage, do not operate the cooling system when the outdoor temperature is below 50°F (10°C).
Program schedule override (permanent)
Press HOLD to permanently adjust the temperature. This will override the temperature settings for all time periods.
The “Hold” feature turns off the program schedule and allows you to adjust the thermostat manually, as needed.
Whatever temperature you set will be maintained 24 hours a day, until you manually change it, or press RUN SCHEDULE to cancel “Hold” and resume the programmed schedule.
NOTE: Make sure the thermostat is set to the system you want to control (heat, cool or auto).
Auto changeover (heat/cool)
Auto Changeover is a feature used in climates where both air conditioning and heating are used on the same day. When the system is set to Auto, the thermostat automatically selects heating or cooling depending on the indoor temperature.
Heat and cool settings must be at least 3 degrees apart. The thermostat will automatically adjust settings to maintain this 3-degree separation (called“Deadband”).
The 3-degree separation between heating and cooling set temperatures is fixed, and cannot be changed.
- Press the system button until the screen displays “Auto”.
NOTE: The Auto system setting may not appear, depending on how your thermostat was installed
Resideo Inc., 1985 Douglas Drive NorthGolden Valley, MN 5542233-00303EFS—05 M.S. Rev. 07-20 | Printed in the United States.www.resideo.comThis product is manufactured by Resideo Technologies, Inc., Golden Valley, MN©2020 Resideo Technologies, Inc. The Honeywell Home trademark is used under license from Honeywell International Inc.All rights reserved.
[xyz-ips snippet=”download-snippet”]