Shark QZ163HQ Cordless Vacuum User Guide

ROCKET® PROCORDLESS VACUUMQUICKSTART GUIDEQZ163HQ

Please make sure to read the enclosed Shark® Owner’s Guide prior to using your vacuum.For questions, visit us online at sharkclean.com/supportRegister your vacuum at registeryourshark.com

ASSEMBLYWHAT’S INSIDE:

A Handheld VacuumB Dirt Engage™ Floor NozzleC MultiFLEX® WandD Pet Multi-ToolE 8″ Crevice Tool F ChargerG Li-Ion Battery (Pre-Installed)H HEPA Post-Motor Filter (Pre-Installed)I Wide Upholstery Tool

For complete maintenance instructions, see the enclosed Owner’s Guide.For additional parts and accessories, visit sharkaccessories.com.For additional batteries and charging accessories, visit sharkclean.com/batteries.

POWER SETTINGS

OFF

Slide switch to the top to turn off the power. To begin vacuuming in Standard Mode, slide switch to the appropriate setting.

BARE FLOOR SETTING 

Bare Floor/Area Rugs Slide switch to the middle. The brushroll spins slowly to clean bare floors and small area rugs.

CARPET SETTING

CarpetSlide switch to the bottom. The brushroll spins faster to pick up debris below the surface of your carpets.

BOOST MODE

For an added boost in power, pull the Trigger on the handheld vacuum. Release it to return to standard power.NOTE: For deep cleaning per ASTM F 608 (embedded dirt in carpets) please select the Carpet setting and pull the trigger to go into Boost mode.NOTE: Select Carpet setting for stuck-on dirt and debris.

CHARGING

Easily Insert or Remove the Li-Ion BatteryTo insert, slide the battery into the slot in the back of the handheld vacuum. To remove, press and hold the  Battery Release Button then slide out the battery.

LI-ION BATTERY

In Use

Charging

NOTE: Full charge takes approximately 3 hours.NOTE: The battery comes partially charged. Charge fully before first use.

Battery Runtime

MODE MINUTES
Hand Vac 40
Bare Floor/Standard Mode 25
Carpet Mode/Standard Mode 20
Boost Mode (Hand Vac) 10

MULTIFLEX® REACH

Press the MultiFLEX Lock Release button to lower the angle of the wand to increase your reach.

MULTIFLEX STORAGE

To store, press the MultiFLEX Lock Release button and fold the handheld vacuum forward.To vacuum, lift up the handheld vacuum by pressing the MultiFlex Lock until the wand locks in place.

EMPTYING THE DUST CUP

  1. To empty the dust cup, first, disconnect the handheld vacuum from the wand by pressing the Wand Release button and pulling up the handheld vacuum.
  2. Position the dust cup over a trash bin and slide the CleanTouch™ Dirt Ejector forward.

report this ad

© 2020 SharkNinja Operating LLC. MULTIFLEX, SHARK, and ROCKET are registered trademarks of SharkNinjaOperating LLC. CLEAN TOUCH and DIRT ENGAGE are trademarks of SharkNinja Operating LLC.QZ163HQ_QSG_MP_Mv2

References

[xyz-ips snippet=”download-snippet”]


Posted

in

by