Mpow isnap x2 Flexible Tripod PA203A / MPPA203AB User Manual

USER MANUAL

Mpow isnap x2Flexible TripodPA203A / MPPA203AB

PACKAGE CONTENTS

DIAGRAM

1. 1/4″-20 Screw
2. Pan-and-tilt Head
3. 1/4″-20 Screw
4. Pan-and-tilt Head
5. Flexible Tripod
6. Anti-skid Foot Pad
7. 360° Ball Head
8. Adjusting knob for Ball Head
9. Angle Adjustment Knob for Tripod

2-LEVEL ADJUSTABLE TRIPOD

BLUETOOTH CONNECTION

1. Turn the switch on the remote control to “On”, and the blue light flashes to show that it enters the pairing mode.
2. Turn on Bluetooth on your phone and pair with “Mpow isnap X2”. Once paired, the light turns off.

Tips: The battery can be replaced. No need to charge.

BATTERY REPLACEMENT

INSTALLATION

Mode 1

Mode 2

For Phone

1. Loosen the adjustment knob to adjust the 1/4″-20 screw to the right position.
2. Align the hole on the phone holder with the 1/4″-20 screw, then rotate to fix it.

For Camera

Connect the 1/4″-20 screw to the screw thread at the bottom of the camera and then tighten to fix it.

For GoPro

Connect the GoPro adapter to the pan-and-tilt head, then install the GoPro with the protective housing on the GoPro adapter and tighten it.

NOTE:

1. If the remote control cannot control the phone to take photos, please set the volume button on your phone to act as the shutter button.
2. To ensure the safety of the installed phone/camera, please carefully unfold the tripod.
3. Before use, please make sure that each knob is tightened and the tripod is securely placed.
4. Please remove the camera or phone from the tripod when moving to another shooting scene.
5. Please do not overload the tripod, as this may cause damage to the product (Max.load:1.5kg/3.3lbs).

Questions about your Manual? Post in the comments!