AirFree T800 Instruction Manual
IMPORTANT SAFETY INSTRUCTIONS
When installing and using this electrical equipment, basic safety precautions should always be followed, including the following:
READ AND FOLLOW ALL INSTRUCTIONS.
Airfree® is not intended for use by persons with reduced physical, sensory or mental capabilities, or lack of experience or knowledge. Children should be supervised to ensure that they do not play with the appliance.
Do not place your Airfree® in direct contact with water or liquids as it can cause an electric and harmful shock hazard and damage to the unit itself.
Do not obstruct Airfree® air outlets with items such as towels, clothing, curtains, as it will increase heating inside the ceramic core causing the device to shut off. If such condition persists a general cut off system will cut power supply requiring replacement of the circuit board by an authorised dealer. This incident is not covered by the Airfree® warranty.
Do not attempt to open Airfree® or touch its internal components. Do not insert any objects as it may cause electric shock. Any attempt to open or tamper Airfree® will void the warranty.
To clean Airfree®, unplug it from the electric outlet and use a dry cloth to wipe off its surface. Do not attempt to open Airfree® to clean it inside which is not necessary.
Always keep Airfree® in its vertical position as shown in the picture, otherwise the unit will be shut off until it goes back to the vertical position.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons or any authorised warranty service shop to avoid potential hazard events. When returning your Airfree® for repair please make sure it is well protected preferably inside its original box, to avoid additional damages.
Airfree® shall not be placed near flammable and toxic products.
SAVE THESE INSTRUCTIONS
Installing and Connecting
Plug the power cord into the nearest outlet. Make sure the surface is dry (never place Airfree® on wet floor or immerge it in water). Make sure the On/Off led is on. After 30 minutes the top lid should be warm.*
Place Airfree® on a flat surface preferably not exceedingm 30’ / 75 cm from the floor, not under furniture, shelves, or behind curtains as it will interfere with air flow and Airfree® efficiency in destroying microorganisms.
Check if the area is compatible with the unit capacity to achieve best unit performance. Using Airfree® in rooms larger than its capacity will greatly reduce its purifying capacity.
Airfree® must be continuously on in the same room, 24 hours a day. Nevertheless, temporarily removing it from the room will allow new microorganism contamination to grow but it will be destroyed when Airfree® is plugged in again. The longer the period without Airfree® the higher the new contamination in the room.
Airfree® is to be used preferably in rooms larger than 43 sq. ft. or 353 cu. ft. / 4 m² or 10 cm³.
Rooms with air condition or ventilation will not affect the air sterilization efficiency of your Airfree®. Same for Heating systems.
Airfree® can be placed in corridors but the air sterilization effects will barely have any effect in connecting rooms.
Avoid place the unit near open doors or windows to prevent some of the sterilized air to exit the room.
SHORT POWER CORD INSTRUCTIONS– A short power supply cord is provided to reduce the risk resulting from becoming entangled in or tripping over a longer cord.– Extension cords are available and may be used if care is exercised in their use.– If an extension cord is used, the marked electrical rating of the extension cord should be at least as great as electrical rating of the appliance, and the longer cord should be arranged so that it will not drape over the counter or table top where it could be pulled on by children or tripped over unintentionally.POLARIZATION INSTRUCTIONSThis appliance has a polarized plug (one blade is wider than the brother). To reduce the risk of electric shock, this plug will fit in a polarized outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not modify the plug in any way.
(*) The “Technical Characteristics“ describes which models incorporate the led light and which models needs to be wall mounted.
What Airfree® Destroys
Airfree® and Mold
It is important to stress that Airfree® will not destroy or remove mold from an infected item or surface. Those surfaces must be cleaned manually since they are a continuous source of new spores. Airfree® will destroy airbone molds, spores and prevents them from contaminating other areas, inhibiting the growth of existing and new colonies.
Technical Characteristics
How does Airfree® Work?
Regardless of how hazardous a virus, fungus or bacteria might be they are fully destroyed by the powerful heat inside the TSS™ ceramic core mini ducts. The heat inside the ceramic core forces sterilized air up to the heat exchanger causing air convection, which generates negative pressure underneath the ceramic core, so contaminated air is “sucked” in at Airfree® bottom air inlets in a continuous, silent, and efficient air flow.
Airfree® Description
Frequently Asked Questions
- Are there any side effects?No. Airfree’s new technology uses heat to purify the air with meaningless heat contribution to the room. No side effects, no emissions, NO IONS, nor new particles are generated. Airfree® can be used in homes and offices, quietly, constantly, and efficiently purifying the air.
- Can I install Airfree® in my walking closet ?Yes if larger than 2×2 meters (43 sq. ft. or 353 cu. ft. / 4 m² or 10 m³). Otherwise it might warm up the closet.
- Can I use Airfree® in air conditioned rooms?Yes.
- How do I know if Airfree® is no longer working?Check the top lid, if cold the sterilization system is not working. Please connect it to another outlet and make sure the unit is in its vertical position for at least 1 minute.
- Can I place Airfree® at the corridor to reach adjacent rooms?No. Airfree® will just reduce air pollution in the corridor’s area.
- Can I place Airfree® in a closed room?Yes. Please remember such a room must have at least 43 sq. ft. (353 cu. ft.) / 4 m² (10 m³).
- Should I turn off Airfree® when I leave house?To achieve best performance we recommend to keep Airfree® always on. Turning the unit off will stop the sterilization process allowing the room contamination to grow.
- Can I change Airfree® from one room to another?Airfree® must always be plugged in the same room 24 hours a day. Airfree’s patented technology works gradually so, when removing it to another room the contamination in the original room will start to increase.
- Does CADR measure the effectiveness of the Airfree®?Not at all. CADR is not designed to test the Airfree® technology. The AHAM seal (usually found on the back of an air cleaner’s box) lists three Clean Air Delivery Rate (CADR) numbers: one for tobacco smoke, one for pollen and one for dust. The CADR indicates volume of filtered air delivered by an air cleaner. The reason why CADR is not designed for Airfree® is because Airfree® does not filter but destroys microorganisms instead, such reduction of bacteria, molds, viruses and other microorganisms can only be measured after air sample incubation in a microbiology lab. Airfree® destroys (not trap or attract to other surface) any microorganism regardless of how small they might be. 99.99% of all microorganisms are fully destroyed when passing through the Airfree® patented ceramic core.
- What happens if Airfree® is disconnected or there was a black out?Airfree® will take approximately the same time to recover the previous reduced contamination level.
- Does Airfree® eliminate bacteria and viruses?Yes. Unlike the air filters in the market Airfree® is more efficient with the smallest microorganisms as they are easily carried by Airfree’s airflow into the sterilizing TSS™ ceramic core. Please check the independent bacteria and virus tests at our website.
- How does Airfree® destroy dust mites?Mold reduction in the environment causes reduction in the mold dependant dust mite population. Airfree® also destroys the harmful toxins and fungus freed into the air by dust mite feces and skeletons that trigger respiratory allergies and asthma.
- How does Airfree® eliminate fungi and molds?As mentioned before, Airfree® eliminates airborne microorganisms there included mouds, fungi and spores. By eliminating spores new mold colonies are unlikely to develop, representing less future airborne mold spores. Please check the independent mold tests at our website.
- Does Airfree® reduce tobacco smell?Slightly.
- How does Airfree® destroy viruses?Those microscopic microorganisms are easily eliminated inside Airfree’s ceramic core capillaries. Contrary to other technologies the smallest the microorganisms the easiest they are destroyed inside the TSS™ ceramic core capillaries. Please check the independent virus test at our website.
- Does Airfree® make any humidity level change in the room?No.
- Does Airfree® release any gas or chemical product?No. Airfree’s sterilization process is natural. Please check our website for conclusive tests regarding particles and ozone.
- Does Airfree® heat up a room?Airfree® does not make any noticeable increase in the room temperature. Just for comparison two Airfree® devices plugged in the same room will contribute as much heat as one 155 lb / 70 kg adult.
- Does Airfree® need filter replacement?No.
- Where do the microorganisms go after they are destroyed?All living microorganisms are basically composed by carbon, oxygen an nitrogen. Since Airfree® reaches nearly 400 °F / 200 ºC, all the components decompose into carbone dioxide (the same product released by our respiration) and water. Some carbon (or microscopic ashes) may remain inside the device or over the top lid during the process. It should be noted that all happens in a microscopic level, so all those residues are a very small fraction of the microorganisms original microscopic size, in other words meaningless.
AirFree T800 Instruction Manual – AirFree T800 Instruction Manual –
[xyz-ips snippet=”download-snippet”]