Bissell Lift-Off Deep Cleaner Quick Start Guide

Table of Contents

Bissell Lift-Off Deep Cleaner Quick Start Guide

66E1, 80X9, 30K7, 24A4 SERIES

PLEASE DO NOT RETURN THIS PRODUCT TO THE STOREPLEASE KEEP FOR FUTURE REFERENCE

WARNING:

Refer to the enclosed user guide for complete instructions and important safety notices.

Package contents:

a. Upper Handleb. Portable Spot Cleaner/Basec. 4 Screws – taped to handled. Tool Attachment(s) (varies by model)e. BISSELL 2X Formula (varies by model)

Tools needed: Standard #2 X 4 inch Phillips head screw driver

Color and tools may vary depending on the model you purchased

Assembly

Slide upper handle onto body of machine
Locate the screws (taped to handle) and the 4 screw holes marked by arrowsNOTE: 2 screw holes are located under the support handle
Firmly holding the upper handle in place, screw 2 screws into the marked holes at an upward angle above the support handle
Screw the remaining 2 screws at an upward angle into the marked outmost holes under the support handle.
Wrap power cord around cord wrap (located on the side of the portable spot cleaner)
Attach tough stain tool to end of hose (extra tool storage located on back)
Wrap flex hose and secure with hose latch (located on opposite side of cord wrap)

Before carpet cleaning

Move furniture to another area if cleaning an entire room
Vacuum area with a dry vacuum cleaner
PreTreat spots & stains and heavy traffic areas (optional—see User’s Guide)

Carpet cleaning (upright mode)

Fill the formula & water tanka. Remove the formula tank from the base of the machine (located on back of portable spot cleaner)b. Unscrew the black cap and remove insertc. Fill tank with hot tap water to the WATER fill line and add two ounces of BISSELL 2X formulad. Replace the insert and tighten black cape. Replace formula tank on machine
Cleaninga. Plug the power cord into a proper outlet and press the power buttonb. Check to verify that the heat indicator light is illuminated. If heat indicator light does not illuminate, release the pod and re-secure by pushing firmly until both sides snap into place. NOTE: Allow 1 minute for hot water heater to warm-upc. While pressing the trigger, make one slow forward wet pass and another one backd. Release the trigger and make another slow forward and backward pass over the same area. Repeated passes will help remove moisture.e. Continue passes until the cleaning area is complete
Empty dirty tank when it reaches the “FULL” linea. Press the power button to turn off the machineb. Remove dirty tankc. Unlock the tank lid by rotating the handle over the back of the tankd. Remove lid to pour out dirty water and rinse e. Replace top of tank and rotate the handle forward to lock in place f. Before replacing tank on machine wipe debris from red filter
Refill as needed following step #1 under Carpet Cleaning (Upright Mode) to continue cleaning

WARNING:

Unit will not function correctly if pod is not secured on both sides.

Carpet cleaning (portable mode)

Step on the portable spot cleaning pedal and lift up to release the portable spot cleaner
Fill the tank following instruction #1 under Carpet Cleaning (Upright Mode)
Release flex hose by turning the hose secure latch
Plug power cord into proper outlet and press the power button
Cleaninga. Clean by pressing the trigger on the flex hose to spray solution onto the area to be cleanedb. Slowly scrub the tool back and forth over the soiled surfacec. Tilt the tool forward to suction liquid
Empty dirty tank when it reaches the “FULL” line following instruction #3 under Carpet Cleaning (Upright Mode)
When cleaning is complete, replace unit on base of machinea. Align the product as image 7a shows and firmly push down the portable spot cleaner until it is secured on both sidesb. Check gray latches on both sides to confirm it is secured.

NOTE: Portable spot cleaner must be fully secure to operate in upright mode