adonit B08L4TLWMK 15W Wireless Car Charger User Manual

adonit B08L4TLWMK 15W Wireless Car Charger

PACKAGING LIST

COMPATIBLE DEVICES

Compatible with all Qi enabled devices.

LED MODE

INFOGRAGH

Wireless Holder

MOUNT ON AIR VENT

1. Insert the nut into the ball structure.
2. Tighten the nut to the back thread of the main machine as shown.
3. Insert the clip into the blade of the air vent.
4. Connect the type-c cable to the wireless charging bracket.
5. Connect the other end of the USB to the car charger.
6. Touch the switch to trigger the automatic unlock function. Then place your phone onto the holder for charging and it will lock automatically.

TIPS

1. Do not squeeze or collide.
2. Do not disassemble or throw into fire or water to avoid causing a short circuit
3. Do not use wireless charger in extremely hot, humid or corrosive environment.
4. Do not get too close to the card with magnetic strip or chip (ID card, bank card etc.)to avoid invalidation of magnetic card
5. Please keep minimum 20cm between implantable medical devices(pacemaker, implantable cochlear etc.) to avoid potential interference with the medical device.
6. Keep out of reach of children and pets.

The images in this manual are sketch drawing of actual product only, actual product might be slightly different.*Car Charger is not included, please purchase separately.

Adonit 15WWireless Car Charger M/N:162

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules, These limits are designed to provide reasonable protecti011 against harmful interference in a residential installation. This equipment generates, uses and can radiate radiofrequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measure:

• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver,
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules and RSS-Gen of IC Rules.

Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operationChanges or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment

Operation is subject to the following two conditions:(1) this device may not cause interferences, and (2) this device must accept any interference, including interierence that may cause undesired operation of the device.

For FAQs and more information, please visit: adonit.netf support