Adonit Note 2 User Manual

Table of Contents

User ManualAdonit Note 2

QUICK GUIDE

Switch on

Press the button once to turn on, once LED light turns the Note 2 is active.

Switch off

Press the button once after turned on, or leave idle for 20 minutes.

Charging

The LED light will display red flickering light when the battery is low. To charge, connect the USB-C cable to the charger port of the pen. The red light will remain on while charging and turn blue once fully charged. The device will automatically switch off when charging cable is removed.* Can be used while charging.

Changing the tip

Unscrew in counter-clockwise direction to extract tip and screw in clockwise direction to secure.

COMPATIBILITY

iPad Air (3rd/4th Gen)iPad mini (5th Gen)iPad (6th/7th/8th Gen)iPad Pro (3rd/4th Gen, 11″& 12.9″-inch)*ALL iPad Models must be updated to iOS 13.3 and above

PACKAGING LIST

Adonit Note 2×1
USB-C cable x1
User manual x 1

Adonit Note 2

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.This device complies with Pan 15 of the FCC Rules and

RSS-Gen of IC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and(2) this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’ s authority to operate the equipmentThis device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:(1) this device may not cause interference, and(2) this device must accept any interference, including interference that may cause undesired operation of the device.

For FAQs and more information, please visit:https://www.adonit.net/support/