OWNER’S MANUAL FOR:
Shallow Water HP Series SWHP20 & SWHP40MAX DEPTH 10’
THANK YOU FOR CHOOSING The Airmax® Aeration System
Important Safety Instructions
- Read all operating instructions carefully.
- To reduce the risk of electric shock, connect only to a properly grounded, grounding-type receptacle. If in doubt, have the outlet checked by a qualified
- This unit is to be used in a circuit protected by a ground fault circuit interrupter (GFCI).
- Disconnect unit from the power source before handling or
- Repair or exchange of cable/power cord must be carried through by the supplier/
- This unit has not been investigated for use in the swimming pool
CAUTION
- Never connect to an extension This may result in equipment failure.
- Do not allow anything to rest on the power
- Do not place the cabinet where people may step on the power cord.
- Never override or `cheat’ electrical or mechanical interlock devices.
- Never attempt any maintenance function that is not specified in the user
- Never operate the system if unusual noises or odors are detected. Disconnect the power cord from the outlet and call for
- This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their
- Children should be supervised to ensure that they do not play with the
- The appliance is to be supplied through a residual current device (RCD) having a rated residual operating current not exceeding 30
GROUNDING INSTRUCTIONS — This product must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This product is equipped with a cord having a grounding wire with an appropriate grounding plug. The plug must be plugged into an outlet that is properly installed and grounded in accordance with all local codes and ordinances.
WARNING — Improper installation of the grounding plug is able to result in a risk of electric shock. When repair or replacement of the cord or plug is required, do not connect the grounding wire to either flat blade terminal. The wire with insulation having an outer surface that is green with or without yellow stripes is the grounding wire.
Check with a qualified electrician or serviceman when the grounding instructions are not completely understood, or when in doubt as to whether the product is properly grounded. Do not modify the plug provided; if it does not fit the outlet, have the proper outlet installed by a qualified technician.
For 120 VAC products: This product is for use on a nominal 120V circuit, and has a grounding plug similar to the plug illustrated in sketch A in Figure below. A temporary adapter similar to the adapter illustrated in sketches B and C may be used to connect this plug to a 2-pole receptacle as shown in sketch B when a properly grounded outlet is not available. The temporary adapter shall be used only until a properly grounded outlet (sketch A) is installed by a qualified electrician. The green-colored rigid ear, lug, or similar part extending from the adapter must be connected to a permanent ground such as a properly grounded outlet box cover. Whenever the adapter is used, it must be held in place by a metal screw.
For 230 VAC products: This product is for use on a circuit having a nominal rating of more than 120 V and is factory-equipped with a specific electric cord and plug for connection to a proper electric circuit. Only connect the product to an outlet having the same configuration as the plug. Do not use an adapter with this product. When the product must be reconnected for use on a different type of electric circuit, the reconnection shall be made by qualified service personnel.
Airmax, Inc.15425 Chets Way StreetArmada, MI 48005(866) 4-AIRMAXairmaxeco.com
References
[xyz-ips snippet=”download-snippet”]