Smart Plug and Bulbs
Connect to your Alexa or Google Assistant device to control your devices with your voice.
Try these voice commands:
Amazon Alexa
Alexa, turn off the living room.
Alexa, good morning. Alexa, turn on table lamp.
Google Assistant
Hey Google, turn on the lights.
Hey Google, turn off bathroom plug.
Hey Google, I’m leaving.
How to Set Up and Enable Voice and Out of Home Control for Your Smart Plug and Bulbs
Install
Install your Smart Plug. If pairing with Smart Bulbs, install those in the same room as the Smart Plug.
Download
Download the C by GE app.
Add
Add your Smart Plug to the C by GE app. Then, add Smart Bulbs to the C by GE app in the same room. Follow the instructions in the app to set up your voice assistant.
Voila!
Now you can control your lights with your voice and away from home.
FCC Compliance Statement Compliance Notice:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of FCC rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications that are not expressly approved by the manufacturer could void the user’s authority to operate the equipment.
RF Exposure Information:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 8 inches during normal operation.
RF Exposure Statement:
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This transmitter must be installed to provide a separation distance of at least 8 inches from all persons and must not be collocated or operating in conjunction with any other antenna or transmitter.
CAUTION – High Voltage – Disconnect power supply before servicing Operation temperature: 0-40ºC
For Control of Electronic Ballast, CFL, LED Lamps
Type 1 Enclosure
IP20
Pollution Degree 2
Impulse Voltage: 1500V
Indoor use only.
Models
CPLGSTDBLW1
Smart Plug and Bulbs Installation Manual – Smart Plug and Bulbs Installation Manual –
[xyz-ips snippet=”download-snippet”]