USER MANUALPowerCore Solar 10000Power Bank
Charging Your USB Devices
Charging Your Smart Watches or Bluetooth Earphones
- To activate the trickle-charging mode, press the power button twice. The indicator will turn green.
- Charge your smartwatch, Bluetooth earphones, or other low-power accessories.
- To turn off trickle-charging mode, press the power button once again.
Recharging Your PowerCore Solar
- Recharge Your PowerCore Solar via the USB Ports
When your PowerCore Solar is fully charged, the LED indicator will turn off after 10 minutes.Recharge Your PowerCore Solar via the Solar Panel
When there is sufficient sunlight, PowerCore Solar will be recharged by the solar panel, and the solar charging indicator will turn blue.When the high-temperature indicator turns red, it means PowerCore Solar has exceeded the temperature limit. Let it cool down before using it again.
Solar charging is subject to sunlight intensity and panel conversion rate, so it may take several days to recharge PowerCore Solar. It is recommended to fully charge the battery if you plan on going on a lengthy trip.
Using the Flashlight
- Press and hold the power button for 2 seconds to turn the flashlight on or off.
- Press once to toggle between low light, high light, and SOS flash modes.
Specifications
| Capacity | 10,000 mAh / 38 Wh |
| Input | 5V 2.1A |
| Total Output | 5V3A |
| Size | 164.3 × 78.2 × 19.8 mm / 6.5 × 3.1 × 0.8 in |
| Weight | 267 g / 9.4 oz |
Important Safety Instructions
When using this product, basic precautions should always be followed, including the following:
- Store the product in a cool and dry place.
- Do not store the product in a hot or humid environment.
- Use of a power supply or charger not recommended or sold by the product manufacturer may result in a risk of fire or injury to persons.
- Operating temperature should be between 0℉C to 55℉C/ 14℉F to 131℉F.
- Do not disassemble the product. Take it to a qualified service person when service or repair is required. Incorrect reassembly may result in a risk of fire or injury to persons.
- If the product is not used for long periods of time, you should charge and discharge once every three months.
- When charging a device, the product may feel warm. This is a normal operating condition and should not be a cause for concern.
- In normal conditions, the battery performance will decline over several years.
- Do not dispose of the product in heat or fire.
- Do not clean the product with harmful chemicals or detergents.
- Misuse, dropping, or excessive force may cause product damage.
- When disposing of secondary cells or batteries, keep cells or batteries of different electrochemical systems separate from each other.
- Be aware that discharged battery may cause fire or smoke. Tape the terminals to insulate them.
Declaration of Conformity
Hereby, Anker Innovations Limited declares that the product type A1640 is in compliance with Directives 2014/35/EU, 2014/30/EU & 2011/65/EU.The full text of the EU declaration of conformity is available at the following internet address: https://www.anker.com Hereby, Anker Innovations Limited declares that the product type A1640 is in compliance with the following Directives:The Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment Regulations 2012Electromagnetic Compatibility Regulations 2016Electrical Equipment (Safety) Regulations 2016The full text of the UKCA declaration of conformity is available at the following internet address: https://www.anker.com
This symbol means the product must not be discarded as household waste and should be delivered to an appropriate collection facility for recycling. Proper disposal and recycling help protect natural resources, human health, and the environment. For more information on the disposal and recycling of this product, contact your local municipality, disposal service, or the shop where you bought this product.CAUTION: Risk of explosion if the battery is replaced by an incorrect type.WARNING: The batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio / TV technician for help.
The following importer is the responsible party.Company Name: Fantasia Trading LLCAddress: 5350 Ontario Mills Pkwy, Suite 100, Ontario, CA 91764Telephone: +1-800-988-7973
IC Statement
This device complies with Industry Canada license-ICES-003. Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device.This digital apparatus complies with CAN ICES-3(B)/NMB-3(B).Anker Technology (UK) LtdSuite B, Fairgate House, 205 Kings Road, Tyseley, Birmingham, B11 2AA, United KingdomAnker Innovations Deutschland GmbHGeorg-Muche-Strasse 3, 80807 Munich, GermanyAnker Innovations LimitedRoom 1318-19, Hollywood Plaza, 610 Nathan Road, Mongkok, Kowloon, Hong Kong
Customer Service
 |
18-Month Limited Warranty |
 |
Lifetime Technical Support |
 |
[email protected] |
 |
(US) +1 (800) 988 7973 Mon-Fri 9:00 – 17:00 (PT)(UK) +44 (0) 1604 936200 Mon-Fri 6:00 – 11:00 (GMT) |
Please note that your rights under applicable law governing the sale of consumer goods remain unaffected by the warranties given in this Limited Warranty.Charge Fast, Live MoreFor FAQs and more information, please visit:
anker.com/support
report this ad
References
[xyz-ips snippet=”download-snippet”]