Anker PowerConfUser Manual
At a Glance
| 1 | Multi-function button | 8 | Power button |
| 2 | Volume down button | 9 | Bluetooth button |
| 3 | Mute button | 10 | Bluetooth LED |
| 4 | Phone call button | 11 | USB port (Type-A) for charge-out |
| 5 | Volume up button | 12 | Audio output port |
| 6 | Status LED | 13 | USB port (Type-C) for charge-in |
| 7 | Power LED |
Connecting
a) Connect to your PC by using a USB-C cable
b) Connect to your PC or mobile device via Bluetooth pairingWhen powered on for the first time, PowerConf S3 will automatically enter the Bluetooth pairing mode.
 |
Press | Enter pairing mode |
 |
Flashes blue | Bluetooth pairing |
 |
Steady blue | Bluetooth connected |
- Each time you power on PowerConf S3, it will automatically connect with the last successfully connected device if available.
- To disconnect Bluetooth, press the Bluetooth button again.
Powering On/Off
Press and hold the power button for 2 seconds to power on. The status LED will light on clockwise and then fade out.To power off, press and hold the power button for 2 seconds.
 |
Steady white | Power on |
|
Light off | Power off |
- Once connected to your computer, it will automatically power on.
- It will automatically power off after 30 minutes of inactivity or no source.
 |
Press or press and hold | Volume up/down |
 |
Press | Answer/End a call |
| Press and hold for 2 seconds | Reject a call | |
 |
Press | Mute or restore the microphone |
 |
Press | Play/Pause music |
Status LED behaviors
| Lights up white for 2 seconds | Connected to power or PC |
| Breathes green | Coming call |
| Lights up blue partly | Sound direction detected |
| Lights up blue clockwise or counterclockwise | Increase or decrease volume |
| Turns red | Muted |
| Lights up green | Press the Power button to check the battery level |
Charginga) Charging this product
| Steady red | Being charged |
| Steady white | Fully charged |
| Flashes red | Low battery |
b) Charging an external device
• When powered off or being charged, it won’t charge out.• When the remaining battery is less than 30%, the charge out current will be 5V 
1A; if less than 10%, it won’t charge out.
Audio Output
Connect an external speaker to the AUX OUT port of PowerConf S3 by using an AUX cable (not provided). The audio will be played through the speaker.
Soundcore App
Download the Soundcore App for software updates.
Specifications
Specifications are subject to change without notice.
| Charge input | 5V 2A |
| Charge out | 5V 2.1A |
| Rated output power | 3W RMS |
| Battery capacity | 6700 mAh |
| Charging time | 4 hours |
| Talktime | 24 hours |
| Driver size | 1 x 1.75” (full range) |
| Frequency response | 20 Hz – 20 kHz |
| Bluetooth version | V 5.0 |
| Bluetooth range | 10 m / 33 ft |
[xyz-ips snippet=”download-snippet”]