ANKER PowerCore III Elite User Manual

User Manual

ANKER PowerCore III Elite

 

Charging Your Phone or Tablet

 

Charging Your Bluetooth Earphones or Smart Watches

  1. To activate trickle-charging mode, press the power button twice or press and hold for 2 seconds. The LED indicator will turn green.
  2. Charge your smart watch, Bluetooth earphones, or other low power accessories.
  3. To turn off “trickle-charging” mode, press the power button once again.

 

Recharging Your PowerCore

When your PowerCore is fully charged, the LED indicators will turn off.

 

Specifications

 

Important Safety Instructions

When using this product, basic precautions should always be followed, including the following:

  1. Store product in a cool and dry place.
  2. Do not store the product in hot or humid environment.
  3. Use of a power supply or charger not recommended or sold by the product manufacturer may result in a risk of fire or injury to persons.
  4. Operating temperature should be between 32°F to 104°F / 0℃ to 40℃.
  5. Do not disassemble the product. Take it to a qualified service person when service or repair is required. Incorrect reassembly may result in a risk of fire or injury to persons.
  6. If the product is not used for long periods of time, you should change and discharge once every three months.
  7. When charging a device, the product may feel warm, this is a normal operating condition and should not be cause for concern.
  8. In normal conditions, the battery performance will decline over several years.
  9. Do not dispose of the product in heat or fire.
  10. Do not clean the product with harmful chemicals or detergents.
  11. Misuse, dropping or excessive force may cause product damage.
  12. When disposing of secondary cells or batteries, keep cells or batteries of different electrochemical systems separate from each other.
  13. Be aware discharged battery may cause fire or smoke, tape the terminals to insulate them.

This symbol indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment.

CAUTION: Risk of explosion if the battery is replaced by an incorrect type.

WARNING: The batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like. Extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas.

 

Declaration of Conformity

Hereby, Anker Innovations Limited declares that the product type A1291 is in compliance with Directive 2014/30/EU. The full text of the EU declaration of conformity is available at the following internet address: www.anker.com

Anker Innovations LimitedRoom 1318-19, Hollywood Plaza, 610 Nathan Road, Mongkok,Kowloon, Hong Kong

FCC StatementThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordancewith the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment doescause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  1. Reorient or relocate the receiving antenna.
  2. Increase the separation between the equipment and receiver.
  3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  4. Consult the dealer or an experienced radio / TV technician for help.

The following importer is the responsible party.Company Name: Fantasia Trading LLCAddress: 5350 Ontario Mills Pkwy, Suite 100, Ontario, CA 91764Telephone: +1-800-988-7973

IC StatementThis device complies with Industry Canada license‐ICES-003. Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device.

 

Customer Service

18-Month Limited Warranty

 

Lifetime Technical Support

 

 

 

(US) +1 (800) 988 7973 Mon-Fri 9:00am – 5:00pm (PT)(UK) +44 (0) 1604 936200 Mon-Fri 6:00 – 11:00 (GMT)(DE) +49 (0) 69 9579 7960 Mo-Fr 6:00 – 11:00

Please note that your rights under applicable law governing the sale of consumer goods remain unaffected by the warranties given in this Limited Warranty.

 

References

[xyz-ips snippet=”download-snippet”]


Posted

in

by