anko Personalised Jawellery Set Instruction Manual

anko Personalised Jawellery Set Instruction Manual

CONTENTS:

  • lx carabiner clip
  • lx platic key ring
  • 2 x elastic cords
  • 3 x wax beading cords
  • 4 x satin cords
  • 1000 x charms and beads

TIPS:

  1. After tying the strands in a loop knot, tape the knotted end on your desk to prevent the strands from sliding out. (tape not included)
  2. Make sure the strands lay flat and not twisted.
  3. Slide the beads through the base strands or side strands then continue knotting.
  4. Make sure the tension is distributed evenly between the strands.
  5. Keep the package nearby so that you can look at the picture for inspiration.

HOW TO USE TOOLS

  1. Fold a 70 cm elastic cord in half and pass through the carabiner,
  2. Put the end of the cord down and pull tightly to get o small knot on the carabiner.
  3. Take the combiner through the plastic key ring hole, and buckle up the ends of the carabiner together.
  4. Treat 2 elastic cord as a single strand and slide the beads in until the length can wrap loosely around your wrist, then knot the end of the bracelet, cut the rest off (scissors not included)ALIULT SUPIPVIMIN IS PICOMMLNKI, Recd though the mingled end mornrg am IN; sheet before besynnng Kiec this inttn.Cion shim rot f ASV 10619-w.

Instructions

  1. Grab two strands and fold in half, take the folded ends of strands and tie it in a simple loop knot 10 cm from the end,
  2. Keep two purple strands in the middle and two pink strands on either side. treat the 2 middle strands as a single base strand.
  3. Cross right strand A over middle strands and under the left strand B.
  4. Cross left strand B under middle strands and through the loop over right strand A. pull tight until the knot rises to the top of bracelet.
  5. Cross left strand A over middle strands and under right strand B.
  6. Cross right strand B under middle strands and through the loop over left strand A. pull tight until the knot rises to second row of bracelet.
  7. Slide the beads through the base strands in the process of knotting. Repeat the process until the bracelet is the length that wraps loosely around your wrist. Treat all strands as a single strand and knot the end of the bracelet, then cut the rest off. (scissors not included)
report this ad

WARNING: JAG CORO AHD S14111. PMTS. SITIAIMAX0 04006 HALMD. P101 FCH NUM NS WARS

[xyz-ips snippet=”download-snippet”]

Posted

in

by

admin

Tags:

, , ,