ANTLION AUDIO ModMic Uni Installation Guide

ANTLION AUDIO ModMic Uni Installation Guide

ModMic Uni Installation

Surface Selection

Find a flat spot on the headphones for the 0.5″ circle of adhesive. The adhesive will stick to smooth and mesh surfaces but does not stick well to rubberized surfaces.

  1.  Put the headphones on to ensure the ModMic will reach the corner of your mouth from the desired mounting point.
  2.  Thoroughly clean and dry the surface with the included alcohol pad.
Attaching & Orientation

  1. Attach a base clasp to the top clasp that holds the ModMic’s boom.
  2. Remove the protective backing from the adhesive.
  3. While holding the top clasp, orient the mic boom angle down so it points towards where your mouth will be when using your headphones. (This will reduce the need for additional bends in the boom after installation–see Figure A).
  4. Press the whole mic/clasp down onto the cleaned spot  and hold firmly for 60 seconds. Allow the adhesive to cure for 1 hour.
  5. To reverse the orientation of the boom from left earcup to right, do not remove the boom from the clasp but simply re-bend the cable end of the boom downward in the opposite shape (see Figure B). Always ensure the cable is pointing down to prevent cable breaks.
Getting the most from your ModMic Uni
  1. The mic is sensitive to plosive blast/wind from your mouth, especially P’s (see Figure C).
  2. To lessen unwanted cable torque on the clasp, fold the cable end of the boom so that it is close to the clasp (see Figure D).
  3. Ensure the mic symbol on the boom is pointed towards your mouth (see Figure E for detail).
Do you need a little more help?

Here are some common troubleshooting steps that may help you out.

  1. Ensure the mute switch is in the unmuted position.
  2. Make sure you have the ModMic selected as your default listening device in your recording devices options.
  3. Try multiple ports on your computer/device if you’re having audio quality issues.
  4. If you need additional help contact us at [email protected] 
  5. Some wireless routers may cause interface if close to the mic/cable.
Parts List

One ModMic Uni

In-line mute switch

Carrying case & instruction manual

One alcohol wipe

Two base clasps, one top clasp with cap & extra 3M adhesives

One foam pop filter

10x Cable Clips

www.AntlionAudio.comFacebook: AntlionAudioTwitter: @AntlionAudioFor more information/extra clasps/questions/feedback visit www.AntlionAudio.com. Designed in Portland, Oregon.Manufactured in China. ModMic and Antlion logo are registered trademarks of GTDevice LLC. U.S. and International patents.

 

References

[xyz-ips snippet=”download-snippet”]

Posted

in

by

admin

Tags:

,