audio-technica ATR4650-USB Digital Surface-Mount/Clip-On Microphone User Guide
Choose Configuration
Clip-On or Surface Mount
Clip-onUse clip on back of microphone to secure mic to lapel or other article of clothing. Attach microphone about 6″ below the user’s chin, making sure that it won’t rub against or become covered by a piece of clothing.
Surface MountDetermine what surface you wish to mount the microphone to (computer monitor frame or other suitable surface). Remove backing on the mount’s adhesive pad and adhere mount in position (do not mount to monitor screen).
Plug the cable’s USB-C connector
Plug the cable’s USB-C connector (or USB-A adapter*) into your computer, tablet or smartphone.
When using with equipment that includes a built-in mic, consult that device’s user guide for instructions on disabling its mic
FCC NoticeWarning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
CautionYou are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment.
Note:This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If thisequipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off nd on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Contact:
Responsible Company: Audio-Technica U.S., Inc.Address: 1221 Commerce Drive, Stow, Ohio 44224, USATel: 330-686-2600ICES statement: CAN ICES-3(B)/NMB-3(B)
Audio-Technica Corporation (Headquarters) 2-46-1 Nishi-naruse, Machida, Tokyo, 194-8666, JapanAudio-Technica U.S., Inc.1221 Commerce Drive, Stow, Ohio, 44224, USAwww.audio-technica.com© 2021 Audio-Technica Corporation P52827-02
References
[xyz-ips snippet=”download-snippet”]