ES947C/FM5Cardioid Condenser Boundary MicrophoneUser Manual
Safety precautions
Although this product was designed to be used safely, failing to use it correctly may result in an accident. To ensure safety, observe all warnings and cautions while using the product.Cautions for the product
- Do not subject the product to strong impact to avoid malfunction.
- Do not disassemble, modify or attempt to repair the product.
- Do not handle the product with wet hands to avoid electric shock or injury.
- Do not store the product under direct sunlight, near heating devices or in a hot, humid or dusty place.
Notes on use
- Do not swing or pull with the cable connected to the microphone to prevent the microphone from becoming disconnected or damaged.
- Do not wind the cable around the rack or allow the cable to become pinched.
- The microphone should be placed on a flat, unobstructed mounting surface.
- Placing any object on a surface (such as a conference table) before its finish is fully cured may result in damage to the finish.
Using the product
Included accessories
- Rubber isolator (1)
- Rubber isolator (2)
- Nut
How to mount the product
Table/ceiling hole size (when using isolators)
Table/ceiling hole size (when not using isolators)
Example: Mounting on a table
- Front-of-mic indicator
- Rubber isolator (1)
- Rubber isolator (2)
- Nut
- Table
Switch setting and functions
LED color
 |
1 | 2 | 3 |
| OFF | RED | GREEN | YELLOW |
| 4 | 5 | 6 | 7 |
| BLUE | MAGENTA | CYAN | WHITE |
Connection procedure
The output connector is an XLR-M type with polarity as shown in the figure below.
- PIN1 (ground)
- PIN2 (hot)
- PIN3 (cold)
- Contact closure
- LED control
Dimensions
Specifications
| Element | Fixed-charge back plate, permanently polarized condenser |
| Polar pattern | Cardioid |
| Frequency response | 70 to 15,000 Hz |
| Open circuit sensitivity | -37 dB (0 dB = 1 V/Pa, 1 kHz) |
| Impedance | 60 ohms |
| Maximum input sound level | 134 dB SPL (1 kHz at 1% THD) |
| Dynamic range | 110 dB (1 kHz at Max SPL) |
| Signal-to-noise ratio | 70 dB (1 kHz at 1 Pa, A-weighted) |
| Phantom power requirements | 11-52 V DC, 6.8 mA |
| Weight | 59 g (2.1 oz) |
| Dimensions | 38 mm (1.50”) × 48 mm (1.89”) × 84.8 mm (3.34”) (W × D × H) |
| Output connector | Integral 5-pin XLR-M type |
| Included accessories | Rubber isolator (2 types), Nut |
- 1 Pascal = 10 dynes/cm2 = 10 microbars = 94 dB SPL
- For product improvement, the product is subject to modification without notice.
Polar pattern/Frequency response
Polar pattern
Frequency response
www.audio-technica.co.jpAudio-Technica Corporation2-46-1 Nishi-naruse, Machida, Tokyo 194-8666, Japan www.audio-technica.com©2021 Audio-Technica Corporation Global Support Contact: www.at-globalsupport.com
[xyz-ips snippet=”download-snippet”]