behringer ULTRALINK ULM300LAV User Guide

behringer ULTRALINK ULM300LAV

High Performance 2.4 GHz Digital Wireless System with Lavalier Microphone, Belt-Pack Transmitter and Receiver

Important Safety Instructions

1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other.A grounding-type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
10. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
11. Use only attachments/accessories specified by the manufacturer.
12. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.
13. Unplug this apparatus during lightning storms or when unused for long periods of time.
14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
15. The apparatus shall be connected to a MAINS socket outlet with a protective earthing connection.
16. Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable.
17. Correct disposal of this product: This symbol indicates that this product must not be disposed of with household waste, according to the WEEE Directive (2012/19/EU) and your national law. This product should be taken to a collection center licensed for the recycling of waste electrical and electronic equipment (EEE).The mishandling of this type of waste could have a possible negative impact on the environment and human health due to potentially hazardous substances that are generally associated with EEE. At the same time, your cooperation in the correct disposal of this product will contribute to the efficient use of natural resources. For more information about where you can take your waste equipment for recycling, please contact your local city office, or your household waste collection service.
18. Do not install in a confined space, such as a book case or similar unit.
19. Do not place naked flame sources, such as lighted candles, on the apparatus.
20. Please keep the environmental aspects of battery disposal in mind. Batteries must be disposed-of at a battery collection point.
21. Use this apparatus in tropical and/or moderate climates.

Caution: Risk of fire or explosion if the battery is replaced by an incorrect type.

LEGAL DISCLAIMERMusic Tribe accepts no liability for any loss which may be suffered by any person who relies either wholly or in part upon any description, photograph, or statement contained herein. Technical specifications, appearances and other information are subject to change without notice. All trademarks are the property of their respective owners. Midas, Klark Teknik, Lab Gruppen, Lake, Tannoy, Turbosound, TC Electronic, TC Helicon, Behringer, Bugera, Auratone and Coolaudio are trademarks or registered trademarks of Music Tribe Global Brands Ltd. © Music Tribe Global Brands Ltd. 2020 All rights reserved.

LIMITED WARRANTYFor the applicable warranty terms and conditions and additional information regarding Music Tribe’s Limited Warranty, please see complete details online at musictribe.com/warranty.

ULTRALINK ULM300BP/RL Controls

1. AUDIO LED lights green whenever an audio signal is received from the microphone.
2. BATT(ery) LED lights blue to indicate a healthy battery, and lights red when the batteries need to be replaced.
3. ON/OFF switch powers the belt pack on and off.
4. Battery compartment – slide the door to open. Observe correct polarity when replacing batteries.
5. Input – Plug the lavalier microphone cable into this jack.
6. POWER LED lights when the unit is powered on.
7. AUDIO LED lights whenever an audio signal is received from the transmitter.
8. Connection Meter displays the signal strength of the wireless connection.
9. BATT(ery) LED lights green to indicate a healthy battery, and lights red when the batteries need to be replaced. It will also light red when the transmitter is turned off.
10. OUTPUTS send the audio signal via balanced XLR or ¼” TS cable.
11. DC IN socket accepts the included power adapter.
12. ON/OFF switch powers the unit on and off.

Wireless RangeThe wireless range can reach up to 30 meters (100 feet) with direct line-of-sight between transmitter and receiver, but connection can suffer due to obstacles like walls or other physical structures, or from radio frequency interference. For optimal performance, avoid placing the receiver near other electronics that emit radio frequencies such as computers, wireless routers, cell phones, microwaves, etc.It is recommended to use only one set of ULM300LAV units in any location.If more than one ULM300 series are used simultaneously, keep a minimum distance of 1-2 meters between each microphone/transmitter, between the mics/transmitters and receiver, and 10-15 meters between all used ULM300 series sets.

Battery LifeStandard and rechargeable batteries can be used to operate the ULM300BP belt pack transmitter. Please note that the operation time depends on the type of battery, and that rechargeable batteries have to be charged/discharged several times to get their best performance.

LatencyPlease consider that there is a small but noticeable audio latency (approx. 14 ms) caused by the wireless transmission and digital conversion. This may not cause an issue for standard speech applications, but might cause irritation for sensitive vocalists.

Specifications

ULM300LAV

*Achievable range will be dependent on nearby sources of RF interference and/or line-of-sight obstacles**Measured from analog input to analog output, unity gain operation without wireless compression***Depending on battery type and use pattern

Important information

1. Register online.Please register your new Music Tribe equipment right after you purchase it by visiting behringer.com. Registering your purchase using our simple online form helps us to process your repair claims more quickly and efficiently. Also, read the terms and conditions of our warranty, if applicable.
2. Malfunction.Should your Music Tribe Authorized Reseller not be located in your vicinity, you may contact the Music Tribe Authorized Fulfiller for your country listed under “Support” at behringer.com. Should your country not be listed, please check if your problem can be dealt with by our “Online Support” which may also be found under “Support” at behringer.com. Alternatively, please submit an online warranty claim at behringer.com BEFORE returning the product.
3. Power Connections.Before plugging the unit into a power socket, please make sure you are using the correct mains voltage for your particular model. Faulty fuses must be replaced with fuses of the same type and rating without exception.

FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION

ULTRALINK ULM300BP/RLThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure StatementThis device complies with FCC radiation exposure limits set forth for an uncontrolled environment and it also complies with Part 15 of the FCC RF Rules. This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provided with antenna installation instructions and consider removing the no-collocation statement.

report this ad

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

References

• 
  Behringer | Home