beko ATP 6100 Air Purifier
Please read this user manual first!Dear Valued Customer,Thank you for preferring this Beko appliance. We hope that you get the best results from your appliance which has been manufactured with high quality and state-of-the-art technology. For this reason, please read this entire user manual and all other accompanying documents carefully before using the appliance and keep it as a reference for future use. If you handover the appliance to someone else, give the user manual as well. Follow the instructions by paying attention to all the information and warnings in the user manual.Remember that this user manual may also apply to other models. Differences between models are explicitly described in the manual.
Important Safety and Environmental Instructions
NOTE: Before reading these instructions, please view the corresponding illustrations.NOTE: With proper care and use, this air purifier will give you fresh, clean air for many years.
General Safety
- Check if the voltage indicated on the appliance corresponds to the local mains voltage before you connect the appliance.
- To avoid fire hazard, never put the cord under rugs, or near any heat source.
- Carefully discard any plastic wrap-ping that was used for the pack-aging.
- Do not use the air purifier outside.
- Do not place the unit near any heat source or in direct sunlight.
- Always unplug the air purifier be-fore removing the grill, changing the filters, cleaning the air purifier or whenever it is not in use.
- Do not use in or around water or any other liquids. Do not attempt to wash the unit under running water.
- Use appliance only for intended household use as described in this manual.
- Ensure that all air openings are not restricted or covered in any way.
- Do not place anything on top of the unit.
- Never insert any object into any openings.
- Do not use the air purifier if any part is missing or damaged in any way.
- Do not attempt to repair or adjust any mechanical functions of this unit. If the unit becomes dam-aged call the service number on the back of this manual.
- If the supply cord is damaged, it must be replaced by the manufac-turer, its service agent or similarly qualified persons in order to avoid a hazard.
- The air purifier contains no user serviceable parts and should the product suffer damage or break-down call the service number on the back of this manual.
- Should the air purifier stop work-ing, first check the fuse/circuit breaker at the distribution board is operating, before contacting the place of purchase.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, un-less they have been given super-vision or instruction concerning use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
- This appliance is intended to be used in household and similar ap-plications such as:– Staff kitchen areas in shops, of-fices and other working environments;– Farm houses;– By clients in hotels, motels and other residential type environ-ments;– Bed and breakfast type environ-ments.
- Save these instructions CAUTION: To prevent risk of electric shock, remove cord plug from outlet before activating the appliance. To prevent risk of fire, inspect and clean equipment regularly as noted in this manual.
- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
Compliance with the WEEE Directive and Disposing of the Waste Product:This product complies with EU WEEE Directive (2012/19/EU). This product bears a classification symbol for waste electrical and electronic equipment (WEEE).
This symbol indicates that this product shall not be disposed with other household wastes at the end of its service life. Used device must be returned to offical collection point for recy-cling of electrical and electronic devices. To find these collection systems please contact to your local authorities or retailer where the product was puchased. Each household performs important rolein recovering and recycling of old appliance. Appropriate disposal of used appliance helps prevent potential negative consequences for the environment and human health.
Compliance with RoHS DirectiveThe product you have purchased complies with EU RoHS Directive (2011/65/EU). It does not contain harmful and prohibited materials specified in the Directive.
Package Information
Packaging materials of the product are manufactured from recyclable materials in accordance with our National Environment Regulations. Do not dispose of the packaging materials together with the domestic or oth-er wastes. Take them to the packaging material collection points designated by the local authorities.
Cleaning And Maintenance
1. Turn the air purifier off and unplug it before cleaning.2. The outside of the air purifier can be cleaned with a soft, clean dampened cloth.3. The air outlet and air inlet grill can be cleaned of dust with a small, soft brush.4. If you wish to clean the inside of the air purifier, please only use a dry, soft cloth to wipe it down.5. Wash the Pre-filter by following the operation described in the section of “VACUUM OR WASH THE PRE-FILTER”.6. Do not wash the HEPA filter.
Vacuum Or Wash The Pre-filter
Occasionally vacuum the exterior of the fabric pre-filter to remove dust.Always unplug the unit before removing the fabric pre-filter.
- Carefully rotate the body anti-clockwise and remove it from the air inlet grill.
- Remove the pre-filter from the HEPA filter.
- Wash the pre-filter in the washing machine.
- After the pre-filter is cleaned well and dried, attach the pre-filter onto the HEPA filter.
- Carefully put the HEPA filter with pre-filter into the air inlet grill.
- Put the body onto the air inlet grill, then rotate the body clockwise until the fastener locks into the groove.
How The Air Purifier Works
The air purifier removes up to 99.97% The air purifier removes up to 99.90% of airborne as small as 0.3 microns.
Know Your Air Purifier
Control Panel Introduction
Operating Instructions
Important notes
• Carefully unpack your air purifier.• Select a firm-level place where there are no obstructions to the air inlet grill or air outlet.• Remove all PE bags from filters before use.• Do not point air outlet towards wall.
Controls Introduction
Power buttonTouch the Power button, the machine will start running under the default “AUTO” set-ting, and the indicator of “AUTO” setting will illuminate.Fan speed buttonThere are 4 speed settings including Low, Medium, High and AUTO for selection. Touch the Fan speed button to select your desired speed setting.Timer buttonThe timer allows you to run your air purifier at your convenience, for up to 8 hours. With 3 settings including 2hr, 4hr and 8hr.Dust sensorThis Air Purifier has a built-in smart dust sen-sor which can detect the air quality of current environment automatically, and the air qual-ity can be shown by the air quality indicator which can illuminate in blue, pink and red when the air quality is very good, good and bad accordingly.Ionizer rocker switchThis appliance has an independent Ionizer rocker switch equipped at the bottom of body, feature which, when turned on, releases neg-ative ions into outgoing filtered air to help the air purification process.
To Operate Your Air Purifier
- Connect the appliance with power source, one “Bi” can be heard.
- Touch the Power button once, “Bi-Bi” can be heard, the appliance starts to run under under the default “AUTO” setting, its corre-sponding indicator will illuminate, and the air quality indicator will illuminate in blue, pink or red according to the actual air quality.– Very good air quality: The air quality indicator illuminates in blue.– Good air quality: The air quality indicator illuminates in pink.– Bad air quality: The air purifier illuminates in red.NOTE: Hold and Touch the “Power button” for 2 seconds if you want to enter into the sleep mode. To re-cover, hold and Touch the “Power button” for 2 seconds again.
- And you can select your required speed set-ting by following the operation described in “CONTROLS INTRODUCTION”. After select, the corresponding indicator of selected speed setting will turn on.
- After turn on the air purifier and select your required speed setting, you can activate the timer by following the operation as below: Touch down Timer button on the control panel, one beep “Bi” can be heard. There are 3 settings including 2H, 4H and 8H for selec-tion. After select your required timing, the indicator of selected timing will illuminate. When the timer expires, the air purifier will power off automatically and the indicator of selected timing will extinguish.
- When the filter change indicator illumi-nates in white, it is time to change the HEPA filter. Please change the HEPA filter by following the operation described in the section of “CHANGE THE HEPA FILTER”.
Change The Hepa Filter
Always unplug the unit before changing the HEPA filter.
1. When the filter change indicator illuminates in white, it’s time to change the HEPA filter.2. Turn off the unit and unplug it.3. Carefully rotate the body anticlockwise and remove it from the air inlet grill.4. Remove the HEPA filter out of the air inlet grill.5. Remove the pre-filter.6. Replace a new HEPA filter into the air inlet grill.7. Put the body onto the air inlet grill, then rotate the body clockwise until the fastener locks into the groove.8. Simultaneously hold and Touch the Power and Timer buttons for 3 seconds to activate the filter function.
Technical Data
| Technical and design modifications reserved. | |
| Made in P.R.C. | |
| Model No. | ATP 6100 I |
| Power supply | 100-240V~,50-60Hz |
| Rated power | 21.6W |
| Contact details for obtaining more information | Arcelik A.S. Sutluce, Karaagac Cad. 2-6, 34445 Beyoglu Istanbul Turkey |
| Parameter of External Power Supply | |
| Manufacturer | Debom Technology Co.,Ltd. |
| Model Identifier | DBS024A-1201800G |
| Input Voltage | 100-240V~ |
| Input Frequency | 50-60Hz |
| Input Current | 0.8A Max |
| Output Voltage | 12.0V DC |
| Output Current | 1.8A |
| Output Power | 21.6W |
| Average active efficiency | 88,03% |
| Efficiency at low load (10%) | 79,98% |
| No-load power consumption | 0.070W |
[xyz-ips snippet=”download-snippet”]