BenQ Genie e-Reading lamp
How to Use
How to Install
for Book-Reading
- Place the lamp on the desk
- Align the center of the lamp head with the center of your eyes and ensure that both ends of the lamp head are at the same height
- Adjust the height of the lamp head to make it slightly lower than your eyes
for Screen-Reading
- Place the lamp on the desk
- Adjust the lamp arm to put the lamp head in front of the screen
- Adjust the height of the lamp head to avoid blocking your screen
- Align the center of the lamp head with the center of the screen and ensure that both ends of the lamp head are at the same height
Note : If the lamp head is higher than your eyes, please tilt the lamp head slightly forward to prevent you from looking directly into the light
How to Assemble
- Insert the small metal shaft on the bottom of the lamp shade into the top of the lamp arm
- Tighten the two screws with the hex L-key to secure the lamp head to the lamp arm
- Clip the rubber cover into the groove on the lamp arm to cover the screws
- Press the power cord into the groove on the lamp arm and leave at least 8 cm on the top in order to tilt the lamp head freely
- Connect the power cord to the power adapter
- Plug the adapter into a power outlet
Quick Start Guide
- Touch the metal ring to turn on/off. Touch and hold the metal ring to activate e-Reading Mode ( The e-Reading Mode indicator will light up ).
- Rotate the dial to adjust brightness.
- Press and rotate the dial to adjust color temperature.Press and rotate the dial again to return to brightness adjustment.
- Do not push downwards past the point of pivot.
- Do not hold the metal ring when adjusting the angle of the lamp.
- Please hold the stand and the arm when moving the lamp.
For Screen Reading :
- Position the lamp head in front of the screen.
- The center of the light source should be aligned with the center of the screenand both ends of the curved light source should be equal in height.
- The lamp head should be positioned as far away from the screen frame as possible in order to avoid reflected glare. If the lamp head is higher than your eyes, please tilt the lamp head slightly toward the back of the screen to avoid looking directly into the light.
For Paper Reading :
report this ad
- Align the center of the light source with the center of your eyes and ensure that both ends of the curved light source are equal in height.
- Adjust the lamp head so that it is slightly lower than your eyes.Otherwise, please tilt the lamp head slightly forward to avoid looking directly into the light.
References
[xyz-ips snippet=”download-snippet”]