BETAFPV Nano TX Module User Manual
Welcome to ExpressLRS!
BETAFPV Nano F TX module is based on ExpressLRS project, open source RC link for RC applications. ExpressLRS aims to achieve the best possible link preformance in both speed, latency and range. This makes ExpressLRS one of the fastest RC links available while still offering long-range preformance.
Github Project Link: https://github.com/ExpressLRSFacebook Group: https://www.facebook.com/groups/636441730280366
Specifications
- Packet refresh rate: 25Hz/100Hz/500HZ
- RF output power: 100mW/250mW/500mW
- Frequency bands (Nano RF Module 2.4G version): 2.4GHz ISM
- Frequency bands (Nano RF Module 915MHz/868MHz version): 915MHz FCC/868MHz EU
- Input voltage: 5V~12V
- USB port: Type-C
BETAFPV Nano F module is compatible with radio transmitter which has the nano module bay (AKA lite module bay, e.g. Frsky Taranis X-Lite, Frsky Taranis X9D Lite, TBS Tango 2).
Basic Configuration
ExpressLRS uses the Crossfire serial protocol (AKA CRSF protocol) to communicate between the radio transmitter and the Nano RF module. So make sure your radio transmitter support the CRSF serial protocol. Next, we use the radio transmitter with OpenTX system to show how to setup the CRSF protocol and LUA script.
Note: Please assemble the antenna before power on. Otherwise, the PA chip in the Nano TX module will be damaged permanently.
CRSF Protocol
ExpressLRS uses the CRSF serial protocol to communicate between the radio transmitter and the RF TX module. To set this up, in OpenTX system, enter into model settings, and on the “MODEL SETUp” tab, turn off the “Internal RE” Next enable “External RF” and select “CRSF” as the protocol.
LUA Script
ExpressLRS use the OpenTX LUA script to control the TX module, like bind or setup.
- Save the ELRS.lu script files onto the radio transmitter’s SD Card in the Scripts/Tools folder;
- Long press the “SYS” button (for RadioMaster T16 or similar radios) or the “Menu” button (for Frsky Taranis X9D or similar radios) to access the Tools Menu where you can find ELRS script ready to run with only one click;
- Below image show the LUA script run successfully;
- With the LUA script, pilot could check and setup some configurations of the Nano F TX module.
Note: The newest ELRS.lu script file is available in BETAFPV Support website (Link in More Information Chapter).
Bind
Nano RF TX module could enter binding status via ELRS.lua script, as description in “LUA Script” chapter.
Besides, short press the button on the module could also enter binding status.
Note: The LED will NOT flash when enter binding status. The module will exit from binding status 5 seconds later auto.
Output Power Switch
Nano RF TX module could switch the output power via ELRS.lua script, as description in “LUA Script” chapter.
Besides, long press the button on the module could switch the output power.
The RF TX module output power and LED indication as show below.
More Information
As ExpressLRS project is still in frequently update, please check BETAFPV Support (Technical Support -> ExpressLRS Radio Link) for more details and newest maunal.
report this adhttps://support.betafpv.com/hc/en-us
- Newest user manual;
- How to upgrade the firmware;
- FAQ and troubleshooting.
[xyz-ips snippet=”download-snippet”]