Instructions for Installation of Bird-X Scare Eye RepellerThe Scare Eye will scare away flocks of nuisance birds that are repelled by its bright color and unusual design. The eyes exaggerate the glaring eyes and gaping mouth of a predator bird. Its waving streamers and bobbing and weaving motion simulate a live predator bird which frightens the bird immediately. Scare Eye comes in three colors. Research show maximum effectiveness is obtained by rotating colors. No color should be used for more than three weeks or they will lose its effectiveness.In the package, you will find a card with Mylar eyes. Remove the Mylar eyes from the card and place them in the center of each black circle to form the pupil. You will also find some Mylar streamers. Tie the streamers to the bottom of the balloon with the enclosed string. You will also find a string to attach to the top grommet.WARNING: DO NOT OVER-INFLATE. DO NOT USE A COMPRESSOR. WITH HIGH PRESSURE, THE SCARE EYE MAY BURST.Gardens, Farm Fields, Berry Patches, and VineyardsAttach the Scare Eye to any type of pole (wood, bamboo, PVC pipe) and install it so that the Mylar tail is approximately 12″ above the highest plants. The number of Scare Eye required is in direct proportion to the size of the plot. In most cases, six per acre is a minimum.Orchards & TreesFor maximum effectiveness, the Scare Eye should be installed above trees so that the Mylar tail is approximately 12″ above the tree and very visible to the birds. One Scare Eye per tree is usually sufficient.The Scare Eye will move pest birds from decks, porches, swimming pools, boat docks, homes, stores, and farm buildings. The Scare Eye is for use anywhere bird problems exist outdoors. The Scare Eye does not work well indoors where air currents are not available to move the balloon.If you have a particular problem, call Bird-X at 1.800.662.5021
[xyz-ips snippet=”download-snippet”]