Bissell 1154 Hard Floor Expert Bagless Canister Vacuum User Guide
Table of Contents
Bissell 1154 Hard Floor Expert Bagless Canister Vacuum
Thanks for buying a BISSELL vacuum
We’re glad you purchased a BISSELL vacuum. Everything we know about floor care went into the design and construction of this complete, high-tech home cleaning system.Your BISSELL vacuum is well made, and we back it with a limited two-year guarantee. We also stand behind it with a knowledgeable, dedicated Consumer Care department, so, should you ever have a problem, you’ll receive fast, considerate assistance.My great-grandfather invented the floor sweeper in 1876. Today, BISSELL is a global leader in the design, manufacture, and service of high-quality homecare products like your BISSELL vacuum.
Thanks again, from all of us at BISSELL.Mark J. BissellChairman & CEO
Symbol Definitions
WARNING
An action or attention is needed to this area in order to reduce the Risk of Electric Shock, Fire, or Injury
TIP
Note or hint which is not essential but may improve usability
Guide
Read user guide for complete safety and user instructions
WEEE
DO NOT THROW THE APPLIANCE AWAY WITH THE NORMAL HOUSHOLD WASTE AT THE END OF ITS LIFE, BUT HAND IT IN AT AN OFFICIAL COLLECTION POINT FOR RECYCLING. BY DOING THIS YOU WILL HELP TO PRESERVE THE ENVIRONMENT.
Before cleaning under low furniture, check area first for objects that might harm the unit or block the hose.
Hair, string and small objects can block the hose and tools. Check them occasionally for obstructions.
Use the air flow regulator to reduce air flow as needed when using the tools.
For maximum cleaning performance, check the filters often and clean or replace if necessary
Important Safety Instructions
Read all instructions before using your VACUUM.When using an electrical appliance, basic precautions should be observed, including the following:
WARNING: To reduce the risk of fire, electric shock, or injury:
Do not leave cleaner when it is plugged in.
Unplug from outlet when not in use and before servicing.
Do not use with damaged cord or plug.
To unplug grasp plug not cord.
Do not pull or carry by cord, use cord as a handle, close door on cord, pull cord around sharp corners, run cleaner over cord, or expose cord to heated surfaces.
Hold plug when rewinding the cord onto the reel. Do not allow the plug to whip when rewinding.
Do not use cleaner if it has been dropped, damaged, left outdoors or dropped into water. Have it repaired at an Authorized Service Center.
Do not allow children to use as a toy.
Do not use outdoors or on wet surfaces.
Do not handle cleaner or plug with wet hands.
Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint, hair and anything that may reduce air flow.
Do not use without filters in place.
Do not allow hair, loose clothing, fingers or body parts to get near openings or floor brush in the appliance.
Do not pick up hot coals, cigarette butts, matches or any hot, smoking, or burning objects.
Do not pick up hard or sharp objects such as glass, nails, screws, coins, etc.
Do not pick up flammable or combustible materials (lighter fluid, gasoline, kerosene, etc.) or use in the presence of explosive liquids or vapor.
Do not unplug by pulling on cord.
Do not pick up toxic material (chlorine bleach, ammonia, drain cleaner, etc.).
Do not use in an enclosed space filled with vapors given off by oil base paint, paint thinner, some moth proofing substances, flammable dust, or other explosive or toxic vapors.
Do not use for any purpose other than described in this User’s Guide.
Always turn off this appliance before connecting or disconnecting vacuum hose.
Use only manufacturer’s recommended attachments.
Use only on dry, indoor surfaces.
Keep appliance on a level surface.
Turn off all controls before plugging or unplugging cleaner
Be extra careful when cleaning stairs.
Close attention is necessary when used by or near children.
SAVE THESE INSTRUCTIONS FOR FUTURE USEThis model is for household use only.
THIS APPLIANCE HAS A POLARIZED PLUG.To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install a proper outlet. Do not change the plug in any way.
Product View
Do not plug in your cleaner until you have completely assembled it per the following instructions and are familiar with all instructions and operating procedures.
Hose Connector
Front Cover
Dust Bin (beneath cover)
Big Wheel
Variable Suction Controls
Rewind Button
Power Button
Carry Handle
Power Cord
Filter
Carpet Tool
Hard Floor Tool
Telescopic Wand
Crevice Tool
Dusting Brush
Handle/Hose
Assembly
You do not need any tools to assemble your vacuum cleaner.
Connect the hose to the canister body. Once it snaps, it is in place.a. To disconnect the hose, squeeze the snaps located on the side of the hose connection and pull out
Connect the handle to the telescopic wand.
Connect the desired floor brush to the end of the telescopic wand.
Place the dusting brush and crevice tool in place on the telescopic handle.a. Dusting toolb. Crevice tool
Special Features
a. Variable SuctionThe Hard Floor Expert is equipped with variable suction to easily go from cleaning carpets and hard floors to delicate surfaces like drapes and upholstery.To increase suction power, slide the dial (on the base of the canister) towards the “+” sign. To dial down the suction, slide the dial towards the “-” sign.
b. Hard Floor ToolThe hard floor tool is equipped to clean hard floor surfaces such as wood, tile, and laminate. This tool is ideal for removing fine dirt and debris on hard flooring.Note: The roller brush will only rotate on hard floor surfaces. It can be used to clean carpet, but the brush will not rotate.
c. Carpet ToolMulti-surface brush switch has retractable brushes to clean both carpet and hardwood floor surfaces.
Vacuum Carpeted AreasSet the multi-surface brush switch to the carpet position (brushes should retract).
Vacuum Hard SurfacesSet the multi-surface brush switch to the hard floor position (brushes should be visible).
d. StorageThere are two storage options for your Hard Floor Expert:
Locate the groove behind the machine and connect the floor tool to the baseOr
Locate the groove on the backside of the canister and connect the telescopic wand.
Before using your vacuum, make sure that the dirt cup and all filters are in place. Do not operate your vacuum without the dirt cup and filters. Be careful to avoid injury as cord retracts very quickly Plastic film can be dangerous. To avoid danger of suffocation, keep away from babies and children.
Operations
Locate the power cord on the back of the unit and plug in.Note: The power cord can be pulled out until the yellow mark is visible. Do not pull out past the red mark on the cord.
Turn on the vacuum by pressing the power button on the base of the canister.
When the dust cup reaches the MAX line, turn off the machine and remove the dust cup from the base of the machine, by opening the lid and pulling up
To empty, locate the yellow tab that says “push” and push to empty.
If the yellow cyclone is dirty, it can be removed by rotating it counter clockwise and pulling out. Clean as needed before replacing.
Reassemble the dust cup after cleaning.
When cleaning is complete. Power off the vacuum by pressing the power button on the base of the canister.
Unplug the vacuum from the electrical outlet.
Thermal motor protection
An internal thermal protector has been designed into your cleaner to protect it from overheating.When the thermal protector activates, the main vacuum motor will stop operating. If this happens, proceed as follows:
Turn the cleaner OFF and unplug from electrical outlet.
Check the cleaner for the source of overheating problem (ie. Full dirt cup, dirty filters or clog).
Fix the problem by following the steps in the Operations or Maintenance and Care section.
When the motor cools for approximately 30 minutes, the thermal protector will reset and cleaning may continue. If the cleaner will not turn on or the thermal protector continues to activate, your cleaner may need servicing. Call BISSELL Consumer Care or visit the website.
To reduce the risk of electric shock, turn power switch off and disconnect plug from electrical socket before performing maintenance or care.
Do not operate cleaner with damp or wet filters or without all filters in place.
This product is intended for household use only and not for commercial or industrial use. Vacuuming of dust from products like plaster, concrete or ashes will damage the motor and void the warranty
Maintenance & Care
To maintain maximum performance, perform these simple maintenance steps.
Filter assembly, cleaning, and replacement
Remove dirt bin from the base of the canister.
Locate the filter on the back of the dirt bin and pull the latches to separate the filter from the bin.
Separate the pleated filter from the foam filter.
Clean pleated filter by tapping it lightly against the trash can.
The foam filter can be rinsed under water.Note: Make sure the filter is dry before replacing.
Reassemble the components.
Post-motor filter cleaning and replacement
Locate the post motor filter on the back of the canister.
Remove the filter by pulling down on the tab and pulling out.
Separate the filter from the door.
Tap out the filter or replace if needed.
Reassemble the components.
Hard floor tool cleaning
Use a coin or slotted screwdriver to turn the knob from lock to unlock and remove the roller brush cover.
Remove the brush from the chamber for cleaning.
Replace the brush and secure the cover making sure to lock it in place.
Replacement Parts
These items are available for purchase as accessories for your BISSELL vacuum: To purchase visit www.BISSELL.com.
Part#
Part Name
160-2330
Handle Assembly
160-2085
Pre-Motor Filter / Foam Filter
160-2086
Post-Motor Filter / Unwoven Cloth
160-2084
Pre-Motor Filter / Pleated Filter
160-2094
Post-Motor Filter
160-2088
Dirt Tank
Accessories
These items are available for purchase as accessories for your BISSELL vacuum: To purchase visit www.BISSELL.com.
Part #
Part Name
160-2089
Carpet Tool
160-2091
Telescopic Extension Wand
160-2060
Upholstery Tool
160-2090
Hard Floor Tool
160-2445
Crevice Tool
Troubleshooting
WARNING: To reduce the risk of electric shock, turn power switch off and disconnect polarized plug from electrical socket before performing maintenance or troubleshooting checks.
Problem
Possible causes
remedies
motor notoperating
Check that the plug is connect to the socket securely
Re-plug
Weakened suction power
Full dust cup
empty dust cup
Dusty filter(s)
Check and clean or replace filters
Clog in the hard floor tool or hose
Follow instructions e3 on page 6 for cleaning the hard floor tool.
Variable suction set to the lowest speed
slide the dial towards the “+” to dial up the suction
Power cordcannot be rewound completely
The power cord may pile on one side of the coiler
Pull out a large section of the cord and rewind it
Power cordcannot be pulled out
Power cord may be twisted
Press the Rewind button and rewind or pull out the cord repeatedly
Please do not return this product to the store.Other maintenance or service not included in the manual should be performed by an authorized service representative.Thank you for selecting a BISSELL product.For any questions or concerns, BISSELL is happy to be of service. Contact Consumer Care listed above
Consumer Warranty
This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state. If you need additional instruction regarding this warranty or have questions regarding what it may cover, please contact BISSELL Consumer Care by E-mail, telephone, or regular mail as described below.
Limited Two-Year WarrantySubject to the *EXCEPTIONS AND EXCLUSIONS identified below, upon receipt of the product BISSELL will repair or replace (with new or remanufactured components or products), at BISSELL’s option, free of charge from the date of purchase by the original purchaser, for two years any defective or malfunctioning part.
See information below on “If your BISSELL product should require service”.
This warranty applies to product used for personal, and not commercial or rental service. This warranty does not apply to fans or routine maintenance components such as filters, belts, or brushes.Damage or malfunction caused by negligence, abuse, neglect, unauthorized repair, or any other use not in accordance with the User’s Guide is not covered.
BISSELL IS NOT LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES OF ANY NATURE ASSOCIATED WITH THE USE OF THIS PRODUCT. BISSELL’S LIABILITY WILL NOT EXCEED THE PURCHASE PRICE OF THE PRODUCT.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you.
*EXCEPTIONS AND EXCLUSIONS FROM THE TERMS OF THE LIMITED WARRANTYTHIS WARRANTY IS EXCLUSIVE AND IN LIEU OF ANY OTHER WARRANTIES EITHER ORAL OR WRITTEN. ANY IMPLIED WARRANTIES WHICH MAY ARISE BY OPERATION OF LAW, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED TO THE two YEAR DURATION FROM THE DATE OF PURCHASE AS DESCRIBED ABOVE.
Some states do not allow limitations on how long an implied warranty last so the above limitation may not apply to you.
NOTE: Please keep your original sales receipt. It provides proof of date of purchase in the event of a warranty claim.
Consumer Care
If your BISSELL product should require service:Contact BISSELL Consumer Care to locate a BISSELL Authorized Service Center in your area.
If you need information about repairs or replacement parts, or if you have questions about your warranty, contact BISSELL Consumer Care.