Bissell EV675 Robotic Vacuum Quick Start Guide

Bissell® EV675 Robotic Vacuum Quick Start Guide

2503 SERIES

WARNING

Refer to the enclosed user guide for complete instructions and important safety notices.

Assembly Instructions

Setting Up Your Robot

  1. Place the back of Docking Station firmly against a wall. Ensure there are at least 40 inches to one side, 40 inches to the opposing side and no obstructions in front of the Docking Station.
  2. Insert the Docking Station power adapter plug into the port on the side of the Docking Station and then plug the other end into the wall outlet. Turn ON the unit’s Power Switch and put on the Docking Station.

The first charge will take 4-5 hours.

Pair the Remote to the Robot

NOTE: Be sure to install batteries in the remote.

  1. While the Power Switch on the side of the robot is OFF (0), press and hold the play button on the remote for 5 seconds until the clock icon on the display flashes.
  2. Continue to hold the play button and turn the robot ON (I).

NOTE: The robot will beep three times to indicate that it has successfully paired.

Set the Clock

  1. Set the time by pressing and holding the clock button on the Remote Control until the clock icon on the Remote Control display begins to flash.
  2. Use the directional arrows to set the hour and minute.
  3. Press the clock button again to save the time setting.

NOTE: The robot will beep once to confirm the time has been saved.

Package Contents

NOTE: Standard accessories may vary by model.

Schedule Cleaning Sessions

NOTE: Be sure the clock is set to the correct time before scheduling cleaning sessions.

  1. Press the schedule button on the Remote Control. The icon will begin to flash on the Remote Control display.
  2. Use the directional arrows to set the hour and minute for your robot to start cleaning.
  3. Press the schedule button again to save the schedule setting.

NOTE: The robot will beep once to confirm the schedule has been saved.

NOTE: To cancel a scheduled cleaning session, press and hold the schedule button on the remote.

Getting Ready to Clean

With Remote Control

NOTE: Be sure the Power Switch on the Robot is set to the ON position.

You can change the cleaning pattern of the robot by pressing one of the following buttons:

Without Remote Control

  1. Press the Power Switch to the ON (I) position.
  2. Press the Start/ Stop Button on the top of the robot to start cleaning.
  3. When finished, press the Start/ Stop Button again to stop the robot.
  4. When the vacuum is in standby mode, press the Start/ Stop button twice continuously. The vacuum goes into recharging mode with the button flashing blue.

Status Light Notifications

Status Light Colour Status
Breathing Blue Charging
Power Light Off Robot Fully Charged
Solid Blue Cleaning
Flashing Blue Returning to Docking Station
Flashing Red Error: Check Cliff Sensors, Battery Power Low, Robot is Trapped
Solid Red Error: Check Wheels, Edge Cleaning Brushes, Brush Roll, and Bumper

FOR ADDITIONAL INFORMATION ON ERROR NOTIFICATIONS AND OTHER TROUBLESHOOTING TIPS, PLEASE REFER TO PAGES 12 AND 13 IN THE USER GUIDE.

Bissell EV675 Robotic Vacuum Quick Start Guide – Bissell EV675 Robotic Vacuum Quick Start Guide –

[xyz-ips snippet=”download-snippet”]

Posted

in

by

admin

Tags:

, , ,