bodum Coffee Maker with extra lid Instruction Manual

bodum Coffee Maker with extra lid

HOW TO MAKE HOT COFFEE

HOW TO MAKE COLD COFFEE

Instructions for Use

Please read these instructions carefully before you use your device for the first time. Retain these user instructions for future reference.

HOW TO MAKE HOT COFFEE
  1. Place pot on a dry, flat, nonslip surface. Hold handle firmly.If necessary turn the lid counter clockwise to unlock (1A), then pull the plunger unit straight up and out of the pot (1B).Note: Insure the filter unit is properly assembled before use.
  2. For each cup (1.25 dl or 4 oz), put 1 rounded tbsp or 1 BODUM® scoop of coarse ground coffee into the pot.CAUTION: Use only coarse ground coffee. Fine grind can clog the filter and create high pressure. Place coffee maker on a heat proof, non-slip surface.
  3. Pour hot (not boiling) water into the pot. Leave a minimum of 2,5 cm/1 inch of space at the top. Stir the brew with a plastic spoon.CAUTION: Metal spoons can scratch or chip the beaker and cause damage.
  4. Place the plunger unit on top of the pot. Turn lid to close off the pour spout opening (4A). Or if it has locking lid turn it clockwise to gently snap into the lock (4B). Do not press down. Let the coffee brew for at least 4 min.
  5. Hold the pot handle firmly with the spout turned away from you, then using just the weight of your hand, apply slight pressure on top of the knob to lower the plunger straight down into the pot. Lowering the plunger slowly with minimal pressure produces best results. If the filter clogs or it becomes difficult to push down the plunger you should remove the plunger from the pot, stir the brew and then slowly plunge again. WARNING: Using exces sive force can cause scalding liquid to shoot out of the pot.
  6. Turn the lid to open the spout (6A) and then pour coffee. Or if it has locking lid assure it is in locked position (6B) before pouring.
  7. Cleaning – Remove the lid and unscrew the filter assembly. Clean all parts after each use.
HOW TO MAKE COLD COFFEE
  1. Place pot on a dry, flat, nonslip surface. Hold handle firmly. If necessary turn the lid counter clockwise to unlock (1A), then pull the plunger unit straight up and out of the pot (1B).Note: Insure the filter unit is properly assembled before use.
  2. Add coarse ground coffee.We recommend to double your usual amount of coffee.
  3. Add fresh cold water and stir with a plastic spoon.CAUTION: Metal spoons can scratch or chip the beaker and cause breakage.
  4. Put the lid on the coffee press. Place it in your refrigerator and let the coffee brew from 12 to 24 hours.
  5. After the brew, take the coffee press from the refrigerator and replace the lid with the plunger filter lid. Turn lid to close off the pour spout opening (5A). Or if it has locking lid turn it clockwise to gently snap into the lock (5B).
  6. Hold the pot handle firmly with the spout turned away from you, then using just the weight of your hand, apply slight pressure on top of the knob to lower the plunger straight down into the pot. Lowering the plunger slowly with minimal pressure produces best results. If the filter clogs or it becomes difficult to push down the plunger you should remove the plunger from the pot, stir the brew and then slowly plunge again. WARNING: Using excessive force can cause liquid to shoot out of the pot.
  7. Turn the lid to open the spout (7A) and then pour coffee.Or if it has locking lid assure it is in locked position (7B) before pouring.
  8. Serve with ice and enjoy your cold brewed coffee.
  9. Cleaning – Remove the lid and unscrew the filter assembly.Clean all parts after each use.

SAFETY INSTRUCTIONS

  • Not for stove top use.
  • Check beaker for scratches, cracks or chips. Do not use a pot which is scratched, chipped or cracked. Install a replacement beaker before using the pot again.
  • Keep children away while using. Hot water is a hazard to small children!
  • Do not allow children to use this coffee maker.

SCALD HAZARD

  • Excessive plunging force can cause scalding hot liquid to shoot out of pot.
  • Do not plunge with force.
  • Use only coarse ground coffee.

Spare parts

Plastic:Item number: 1508-10P-1

Plastic:Item number: 1508-10P-DW

BODUM® AG, CH-6234 Triengen, BODUM® is a registered trademark of Pi-Design AG, Switzerland.www.bodum.com

report this ad

References

[xyz-ips snippet=”download-snippet”]

Posted

in

by

admin

Tags:

, , , ,