comfort CF-18W 18 Inch Stand Fan Instruction Manual

INSTRUCTION MANUAL18″STAND FANMODEL: CF-13W

MADE IN P.R.C

WARNING

If the power supply cord is damaged. Has it been replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid any hazard?This appliance is not intended for use by persons(including children)with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.The appliance is not to be used by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instructionChildren being supervised not to play with the appliancePlease read this instruction manual carefully before using it and save it for future reference.

Model: CF-18WVoltage:220-240V­Frequency:50/60HzPower:80W

PART NAME:

RULES FOR SAFE OPERATION

1. Never insert fingers, pencils, or any other items through the fan guard, when the unit running
2. Disconnect the fan when moving it
3. Disconnect the fan when removing fan guards for cleaning
4. Make sure the fan unit is positioned on a stable surface to avoid overturning.
5. Do not use a fan near a window. Rain may cause electrical shock.

HOW TO ASSEMBLE THE FAN

WARNING: Please unplug the fan before installing to the wall and the grid, Install the fan and grid completely(as per sketch)before using.Foot base assembly:

1. Put the foot base on the flat ground.
2. Fix the shaft of the fan on the base foot tightly with a screw and spacer
3. 0pen fasten and put the base on the foot through the upper column, then use two screws to fix the base on its foot. Finally, put base decorated cover on the base through the column.

Fan Body Assembly:

1. Attach the standpipe to the fan base with the attached screws.
2. Pull out the extension pipe to the required height and fasten the pipe locking nut tightly.
3. Mount the fan head assembly to the fan-stand assembly and fasten the thumbscrew.
4. Remove the blade locking nut and the rear guard locking nut from the motor shaft, attach the rear guard to the head by tightening the locking nut firmly.
5. Attach the fan blade to the motor shaft and tighten the blade locking nut firmly.
6. Mount the front guard to rearguard with a plastic hoop and tighten the screw firmly.

HOW TO OPERATE THE FAN

1. There is an oscillation knob at the back of the knob head. To make the fan head oscillate, simply push down the clutch knob. To stop the oscillation, pull out the clutch knob.
2. The wind direction can be adjusted upward or downward by simply raising or pressing the fan head to the required tilt angle.
3. The wind can be chosen by pushing the corresponding speed button.
4. Turn on the timer to preset the running time.A)Turn the knob of the timer switch clockwise to set the time, the fan will automatically stop when the time comes.B)increase the timer switch is not used, set the timer at position ON.

HOW TO CLEAN

1. Please disconnect the fan unit from the power supply before cleaning it.
2. Only clean the surface of the fan body with mild detergent and a soft cloth.Please disassemble the fan guard and blade from the fan body before cleaning them. After drying up, it may be reassembled.
3. Please add a few drops of lubricant to the base of the motor shaft after cleaning to extend motor life.

PLEASE FILL IN YOUR DETAILS FOR FUTURE USEGUARANTEE CARD

report this ad

CUSTOMER’S DETAILSNAME OF BUYERADDRESSTELEPHONEDETAILS OF SHOPNAME OF SHOPRECEIPT VOUCHER NO.DATE OF PURCHASEAPPLIANCE DETAILSTYPE OF APPL I ANGEMODEL NO.SER I AL NO.