Comsol 10W Wireless Fast Charging Stand User Manual

Table of Contents

Comsol 10W Wireless Fast Charging Stand

Compatibility

Compatible with Qi-enabled devices* including

iPhone X
Samsung SB/SB+
Sony Xperia XZ2
iPhone 8
Samsung S7/S7 Edge
Nokia 8 Sirocco
iPhone 8 Plus
Samsung Note 8
LG G7 ThinQ
Samsung S9/S9+
Samsung Note s
LG V30+

Features

Two charging coils enable large wireless coverage to allow charging in portrait or landscape mode
Supports 1 OW wireless fast charging for compatible devices such as Samsung Galaxy S9, S9+, SB, SB+, Note 8, S7 & S7 Edge
Supports 7.SW Apple wireless fast charging for iPhone X/8/8 Plus
Supports SW standard wireless charging for all Qi enabled devices
No need to remove your protective case. Works with most cases up to 3mm thick
LED indicator to show charging status
Smart IC enables energy saving mode when device is fully charged
Full safety protection for your devices with Qi certified temperature control, strict voltage regulation & short circuit protection
Includes 1.Sm micro USB cable to connect charging stand to USB wall charger (USB wall charger not included)
Check with device manufacturer for Qi wireless compatibility
When connected to a Quick Charge 2.0 or 3.0 wall charger (not included)

Wireless Charger Operation

Using the included micro USB cable, connect the wireless charging stand to a USB wall charger (USB wall charger not included)
It is recommended to use original or reputable 3rd party branded USB wall chargers. For faster charging limes it is recommended to use a USB wall charger with a minimum of 2A output
When connected to the USB charger, the red LED will be on for 3 seconds to indicate the charging stand is powered on and in stand-by mode
Place your Qi enabled wireless phone on the charging stand and your phone should start charging automatically
The LED will flash green to indicate charging
If your phone does not start charging, move your phone until the correct position is found and your phone starts charging
When your phone is fully charged, the Smart IC enables energy saving trickle charge modePlease NoteTo achieve 1 OW fast charging for Android devices or 7.5W fast charging for Apple devices, the charging stand needs to be connected to a Quick Charge 2.0 or 3.0 wall charger (not included)

Specifications

Wireless Standard: WPC/Qi (v1 .2.3)
Quantity of Wireless Charging Coils: Two Coils
Input: DC SV 2A or DC 9V 2A
Output: SW I 7 .SW I 10W (Max)
Working Frequency: 11 Oto 20SKH
Charging Distance: 3 to 8mm
Charging Efficiency: > 72%
Dimensions: 125 x 70 x 98mm
Weight: 178g

Important Safety Instructions

Only use original or reputable third party chargers and cables
Do not get wet to avoid causing short circuit damage and leakage
Do not use in extreme hot, humid or corrosive environments to avoid short circuit damage and leakage
Do not place too close to magnetic strip or chip ID card to avoid magnetic failure
Do not place within 20cm of implantable medical devices (pacemaker, cochlear implant etc.) to avoid potential interference
Do not clean with harmful chemicals or detergents
Misuse, dropping or excessive force may cause damage to the charging stand

Please Note: When wirelessly charging a device, the wireless charger and your device may feel warm. This is a normal operating condition and should not be cause for concern.

iPhone is a trademark of Apple inc., registered in the U.S. and other countries.The ‘Qi’ Symbol is a trademark of the Wireless Power Consortium. Android is a trademark of Google Inc.

Qi CertifiedCertification program ensures this charger has passed rigorous tests to guarantee safety, compatibility and energy efficiency.