Connects2 Vision CAM-26 IR Rearview Camera User Manual
PRODUCT FEATURES
Image Sensor: 7080TV Lines: 480Lumen: 0.1 LuxHorizontal Angle: 170 DegreesVertical Angle: 120 DegreesTV System: NTSCVideo Output: 1.0V p-p 75ohmOperating Voltage: 12V DC (Negative Ground)Current Consumption: 114mA @ 13.8VWaterproof Rating: IP68Operating Temperature: -20 Degrees C to +70 Degrees CParking Lines: YesImage: MirrorInfra-Red LED’s: Yes
DISCLAIMER
Prior to Installation
Read the manual prior to installation. Technical knowledge is necessary for installation.Please ensure you use the correct tools to avoid damage to the vehicle or product.
Connects2 can not be held responsible for the installation of this product.
Technical Support
Connects2 want to provide a fast and suitable resolution should you encounter any technical issues. With this in mind, when contacting Connects2, try to provide as much Information as possible. This will speed up the process and help us to help you.Please use our dedicated online technical support centre: support.connects2.com
CONTENTS
- Camera with 40cm cable to Female DC connector and RCA Female connector
- 1m DC power cable with Male DC connector
- 6m Male to Male RCA extension cable
- 21mm hole saw
- Instructions
INSTALLATION
- Connect the Black wire to a suitable ground and the Red wire to a switched +12V supply.
- If the camera is to be used in the rear of the vehicle, the Red wire should be connected to the reversing light circuit or an interface which provides a reverse signal.
- Select a suitable location for the camera and ensure that the area is free from all cables, fuel & oil. Whenever possible, avoid locations that are subject to road dirt & water spray.
- Aim to mount the camera preferably 45-60cm from the ground and cut a suitable hole using the cutting tool provided.
- Using the supplied video cable, connect the camera to the display screen and ensure that the image is displayed correctly.
Subscribe to our YouTube Channel for installationguides and tips… www.youtube.com/connects2
[xyz-ips snippet=”download-snippet”]